In-situ monitoring for liquid metal jetting using a millimeter-wave impedance diagnostic
Authors:
Open Access
- 18 December 2020
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 10 (1) , 1-9
Abstract
This article presents a millimeter-wave diagnostic for the in-situ monitoring of liquid metal jetting additive manufacturing systems. The diagnostic leverages a T-junction waveguide device to monitor impedance changes due to jetted metal droplets in real time. An analytical formulation for the time-domain T-junction operation is presented and supported with a quasi-static full-wave electromagnetic simulation model. The approach is evaluated experimentally with metallic spheres of known diameters ranging from 0.79 to 3.18 mm. It is then demonstrated in a custom drop-on-demand liquid metal jetting system where effective droplet diameters ranging from 0.8 to 1.6 mm are detected. Experimental results demonstrate that this approach can provide information about droplet size, timing, and motion by monitoring a single parameter, the reflection coefficient amplitude at the input port. These results show the promise of the impedance diagnostic as a reliable in-situ characterization method for metal droplets in an advanced manufacturing system.Keywords
Funding Information
- Lawrence Livermore National Laboratory (19-ERD-008, 19-ERD-008, 19-ERD-008, 19-ERD-008, 19-ERD-008, 19-ERD-008)
- Lawrence Livermore National Laboratory,United States (18-SI-001, 18-SI-001)
This publication has 33 references indexed in Scilit:
- 3D‐Printed Structure Boosts the Kinetics and Intrinsic Capacitance of Pseudocapacitive Graphene AerogelsAdvanced Materials, 2020
- Microstructural Characterization of Pure Tin Produced by the Drop-on-Demand Technique of Liquid Metal JettingMetallurgical and Materials Transactions A, 2019
- Producing solder droplets using piezoelectric membrane-piston-based jetting technologyJournal of Materials Processing Technology, 2019
- Field responsive mechanical metamaterialsScience Advances, 2018
- A Metallographic Review of 3D Printing/Additive Manufacturing of Metal and Alloy Products and ComponentsMetallography, Microstructure, and Analysis, 2018
- 3D Printed Optical Quality Silica and Silica–Titania Glasses from Sol–Gel FeedstocksAdvanced Materials Technologies, 2018
- Investigation of molten metal droplet deposition and solidification for 3D printing techniquesJournal of Micromechanics and Microengineering, 2016
- 3D printed cellular solid outperforms traditional stochastic foam in long-term mechanical responseScientific Reports, 2016
- Solder Jet Printhead for Deposition of Molten Metal DropsJournal of Imaging Science and Technology, 2010
- Drop-on-Demand Solder Droplet Jetting System for Fabricating MicrostructureIEEE Transactions on Electronics Packaging Manufacturing, 2008