Heating-mechanism of gas, short-shot method, and their experimental and benefit analysis on hollow structure of gas-assisted injection-molded specimens
- 26 December 2025
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of Polymer Engineering
- Vol. 46 (2) , 182-193
Abstract
Gas-assisted injection molding (GAIM) introduces high-pressure gas into the mold cavity after molten plastic injection, creating a hollow structure that reduces material usage and improves warpage and cooling deformation, particularly in thick-walled parts. However, conventional GAIM typically employs nitrogen at around 15 °C, which often leads to condensation and pressure drops due to the temperature difference with the molten polymer. These issues result in unstable gas penetration, asymmetric hollow structures, reduced dimensional stability, and surface defects from insufficient gas support. To address these challenges, this study integrates a gas heating module into the GAIM process and systematically evaluates its effects using the short-shot method and spiral-flow specimens. Experimental results show that gas preheating reduces solid material usage by more than 6 % and achieves an average weight reduction above 20 %, attributed to slower cooling and enhanced hollow formation. Heated gas also decreases shrinkage variability by over 20 %, lowers the overall shrinkage rate by ∼5 %, and simultaneously reduces melt pressure by ∼10 % while stabilizing gas output by ∼15 %, thereby improving dimensional stability and process robustness. Furthermore, the hollow ratio is increased by 15–20 % and penetration length is extended by ∼20 %, resulting in more continuous, symmetric, and well-defined hollow structures.Keywords
This publication has 23 references indexed in Scilit:
- Enhancing weld line strength in fiber-reinforced recycled polypropylene through gas-assisted push-pull injection moldingComposites Part A: Applied Science and Manufacturing, 2025
- Experimental analysis of gas-assisted co-injection molding for complex polymer multilayer circular tubular componentsIranian Polymer Journal, 2025
- Experimental analysis of fluid‐assisted injection molding of pipe fittings with different angles by short‐shot methodEngineering Reports, 2022
- Numerical and experimental investigations on the mechanism of flow‐induced fiber orientation in short‐shot water‐assisted injection‐molded short‐glass‐fiber‐reinforced polypropyleneJournal of Applied Polymer Science, 2022
- Feasibility evaluation of gas-assisted heating for mold surface temperature control during injection molding processInternational Communications in Heat and Mass Transfer, 2009
- Birefringence in gas‐assisted tubular injection moldings: Simulation and experimentPolymer Engineering & Science, 2009
- Approximate prediction of gas core geometry in gas assisted injection molding using a short cut methodPolymer Engineering & Science, 2007
- Gas assisted injection molding of a handle: Three‐dimensional simulation and experimental verificationPolymer Engineering & Science, 2005
- Influence of processing conditions and part design on the gas‐assisted injection molding processAdvances in Polymer Technology, 2001
- Development and application of CAE technology for the gas‐assisted injection molding processAdvances in Polymer Technology, 1995