Sources of Thermal Power Generation and Their Influence on the Operating Temperature of Organic Solar Cells
Open Access
- 27 January 2022
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 12 (3) , 420
Abstract
Thermal stability, closely associated with the operating temperature, is one of the desired properties for practical applications of organic solar cells (OSCs). In this paper, an OSC of the structure of ITO/PEDOT:PSS/P3HT:PCBM/ZnO/Ag was fabricated, and its current-voltage (J-V) characteristics and operating temperature were measured. The operating temperature of the same OSC was simulated using an analytical model, taking into consideration the heat transfer, charge carrier drift-diffusion and different thermal generation processes. The simulated results agreed well with the experimental ones. It was found that the thermalization of charge carriers above the band gap had the highest influence on the operating temperature of the OSCs. The energy off-set at the donor/acceptor interface in the bulk heterojunction (BHJ) was shown to have a negligible impact on the thermal stability of the OSCs. However, the energy off-sets at the electrode/charge-transporting layer and BHJ/charge-transporting layer interfaces had greater impacts on the operating temperature of OSCs at the short circuit current and maximum power point conditions. Our results revealed that a variation over the energy off-set range from 0.1 to 0.9 eV would induce an almost 10-time increase in the corresponding thermal power generation, e.g., from 0.001 to 0.01 W, in the cells operated at the short circuit current condition, contributing to about 16.7% of the total solar power absorbed in the OSC.Keywords
This publication has 38 references indexed in Scilit:
- Charge carrier recombination in organic solar cellsProgress in Polymer Science, 2013
- Study of the mechanism and rate of exciton dissociation at the donor-acceptor interface in bulk-heterojunction organic solar cellsJournal of Applied Physics, 2013
- Improved thermal stability of bulk heterojunctions based on side-chain functionalized poly(3-alkylthiophene) copolymers and PCBMSolar Energy Materials and Solar Cells, 2013
- Organic Solar Cells: A Review of Materials, Limitations, and Possibilities for ImprovementParticulate Science and Technology, 2013
- Quantification of Geminate and Non‐Geminate Recombination Losses within a Solution‐Processed Small‐Molecule Bulk Heterojunction Solar CellAdvanced Materials, 2012
- Recombination via tail states in polythiophene:fullerene solar cellsPhysical Review B, 2011
- Long‐Term Thermal Stability of High‐Efficiency Polymer Solar Cells Based on Photocrosslinkable Donor‐Acceptor Conjugated PolymersAdvanced Materials, 2011
- Polymer solar cells with enhanced open-circuit voltage and efficiencyNature Photonics, 2009
- Enhancing the Thermal Stability of Polythiophene:Fullerene Solar Cells by Decreasing Effective Polymer RegioregularityJournal of the American Chemical Society, 2006
- Temperature dependence for the photovoltaic device parameters of polymer-fullerene solar cells under operating conditionsJournal of Applied Physics, 2001