Reaction Properties of Basic Oxygen Furnace Slag and Methane in a Fluidized-Bed Chemical Looping System
Authors:
Open Access
- 28 November 2023
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (49) , 47075-47085
Abstract
In the conventional steelmaking process, slag is the second-largest byproduct. Although most slags have ways to be reused, the demand for small BOF (basic oxygen furnace) slag is still limited. This study aimed to develop a fluidized-bed chemical looping system using BOF slag as an oxygen carrier and methane as a fuel to produce heat for the steelmaking process. The results of the BOF slag reaction test on a batch fluidization and reaction test facility indicated that the methane conversion rate increased with an increase in the methane concentrations and the reaction temperature. As methane concentration increased from 5 to 15 v/v % at the reaction temperature of 950 °C and the fluidized velocity of 5.1 times the minimum fluidized velocity of BOF slag, the methane conversion rate increased from 65.8 to 76.6%. By setting 10 v/v % as the referenced methane concentration, the methane conversion rate corresponded to 71.6%, and as the reaction temperature increased to 980 °C, the methane conversion rate of 85.7% was achieved. The fluidized gas velocity influenced the fluidized state of the oxygen carrier and the gas residence time in the reactor. As the gas velocity was 1.9 times the minimum fluidization velocity of BOF, the methane and oxygen carrier conversion rates reached 83.3 and 13.0% at the referenced methane concentration and reaction temperature of 950 °C. The experimental results could offer the required design and operation parameters for the methane fluidized bed chemical looping system using BOF slag as the oxygen carrier.Keywords
Funding Information
- Bureau of Energy, Ministry of Economic Affairs, Republic of Taiwan
This publication has 25 references indexed in Scilit:
- CO2 Capture for Fossil Fuel‐Fired Power PlantsChemical Engineering & Technology, 2011
- The effect of column diameter and bed height on minimum fluidization velocityAIChE Journal, 2010
- Waste products from the steel industry with NiO as additive as oxygen carrier for chemical-looping combustionInternational Journal of Greenhouse Gas Control, 2009
- Micro fluidized beds: Wall effect and operabilityChemical Engineering Journal, 2008
- Advances in CO2 capture technology—The U.S. Department of Energy's Carbon Sequestration ProgramInternational Journal of Greenhouse Gas Control, 2008
- Mapping of the range of operational conditions for Cu-, Fe-, and Ni-based oxygen carriers in chemical-looping combustionChemical Engineering Science, 2007
- Use of NiO/NiAl2O4 Particles in a 10 kW Chemical-Looping CombustorIndustrial & Engineering Chemistry Research, 2006
- Physical and Chemical Characteristics of Blast Furnace, Basic Oxygen Furnace, and Electric Arc Furnace Steel Industry SlagsEnvironmental Science & Technology, 2000
- Use of steelworks slag in EuropeWaste Management, 1996
- Minimum Fluidization Velocities of Lime and Limestone ParticlesIndustrial & Engineering Chemistry Process Design and Development, 1978