Cetera Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Cetera Chen has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Berlin Huang
National Cheng Kung University
2 shared publications- Tony Yuan
School of Computer Science and Engineering, Beihang University, Beijing, China
2 shared publications Cheng-Hsien Shen
Green Energy and Environment Research Laboratories, Industrial Technology Research Institute, No. 1001, Gaonan Highway, Nanzi District, Kaohsiung 81160, Taiwan, Republic of China
1 shared publicationChing-Ti Kao
Green Energy and Environment Research Laboratories, Industrial Technology Research Institute, Hsinchu 31040, Taiwan, (R.O.C.)
1 shared publicationEric Wang
Green Energy and Environment Research Laboratories, Industrial Technology Research Institute, No. 1001, Gaonan Highway, Nanzi District, Kaohsiung 81160, Taiwan, Republic of China
1 shared publicationHsiu-Hsia Lee
Green Energy and Environment Research Laboratories, Industrial Technology Research Institute, No. 1001, Gaonan Highway, Nanzi District, Kaohsiung 81160, Taiwan, Republic of China
1 shared publication
Latest Publications
- Open Access
- 11 March 2026
- Published by Elsevier in SSRN Electronic Journal
Thermodynamic analysis of Gas Turbine cycle Performance using liquefied NH3, H2, and CH4 fuels
In this study, the performance and NOx emissions for a gas turbine cycle using liquid fuels were thermodynamically analyzed, with the air-fuel (AF) ratio serving as the primary parameter. The liquefied NH3, H2, and natural gas (LNG) were used as the fuels. Three kinds of gas turbine cycle designs were examined. First, the direct adiabatic combustion of re-gasified fuels and air was involved. Under the specified operation conditions, it was found that the thermal efficiency increases with the increased AF ratio, reaches a maximum value, and decreases with increased AF ratio. The AF ratio at which maximum thermal efficiency result are the theoretical air. It was found that LNG has the highest theoretical air as compared with H2 and NH3. It was also found that negative thermal efficiency is possible for an H2-fueled cycle when the excess air is used. In the second cycle design, a reformer was introduced to produce H2-rich fuel from NH3 decomposition. It was found that higher thermal efficiency can be obtained as compared with the direct combustion cases. It was also found that the thermal efficiency of this design increased with the operation pressure and temperature of the reformer. In the third design, a CH4-NH3 mixture was the fuel for the gas turbine cycle. With an increased amount of NH3 in the fuel mixture, the thermal efficiency can be improved while the amounts of NO and CO can be reduced in the combustion product.
- 11 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessThermodynamic analysis of Gas Turbine cycle Performance using liquefied NH3, H2, and CH4 fuels
In this study, the performance and NOx emissions for a gas turbine cycle using liquid fuels were thermodynamically analyzed, with the air-fuel (AF) ratio serving as the primary parameter. The liquefied NH3, H2, and natural gas (LNG) were used as the fuels. Three kinds of gas turbine cycle designs were examined. First, the direct adiabatic combustion of re-gasified fuels and air was involved. Under the specified operation conditions, it was found that the thermal efficiency increases with the increased AF ratio, reaches a maximum value, and decreases with increased AF ratio. The AF ratio at which maximum thermal efficiency result are the theoretical air. It was found that LNG has the highest theoretical air as compared with H2 and NH3. It was also found that negative thermal efficiency is possible for an H2-fueled cycle when the excess air is used. In the second cycle design, a reformer was introduced to produce H2-rich fuel from NH3 decomposition. It was found that higher thermal efficiency can be obtained as compared with the direct combustion cases. It was also found that the thermal efficiency of this design increased with the operation pressure and temperature of the reformer. In the third design, a CH4-NH3 mixture was the fuel for the gas turbine cycle. With an increased amount of NH3 in the fuel mixture, the thermal efficiency can be improved while the amounts of NO and CO can be reduced in the combustion product.
- Open Access
- 28 November 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (49) , 47075-47085
Reaction Properties of Basic Oxygen Furnace Slag and Methane in a Fluidized-Bed Chemical Looping System
In the conventional steelmaking process, slag is the second-largest byproduct. Although most slags have ways to be reused, the demand for small BOF (basic oxygen furnace) slag is still limited. This study aimed to develop a fluidized-bed chemical looping system using BOF slag as an oxygen carrier and methane as a fuel to produce heat for the steelmaking process. The results of the BOF slag reaction test on a batch fluidization and reaction test facility indicated that the methane conversion rate increased with an increase in the methane concentrations and the reaction temperature. As methane concentration increased from 5 to 15 v/v % at the reaction temperature of 950 °C and the fluidized velocity of 5.1 times the minimum fluidized velocity of BOF slag, the methane conversion rate increased from 65.8 to 76.6%. By setting 10 v/v % as the referenced methane concentration, the methane conversion rate corresponded to 71.6%, and as the reaction temperature increased to 980 °C, the methane conversion rate of 85.7% was achieved. The fluidized gas velocity influenced the fluidized state of the oxygen carrier and the gas residence time in the reactor. As the gas velocity was 1.9 times the minimum fluidization velocity of BOF, the methane and oxygen carrier conversion rates reached 83.3 and 13.0% at the referenced methane concentration and reaction temperature of 950 °C. The experimental results could offer the required design and operation parameters for the methane fluidized bed chemical looping system using BOF slag as the oxygen carrier.
- 28 November 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (49) , 47075-47085
Open AccessReaction Properties of Basic Oxygen Furnace Slag and Methane in a Fluidized-Bed Chemical Looping System
In the conventional steelmaking process, slag is the second-largest byproduct. Although most slags have ways to be reused, the demand for small BOF (basic oxygen furnace) slag is still limited. This study aimed to develop a fluidized-bed chemical looping system using BOF slag as an oxygen carrier and methane as a fuel to produce heat for the steelmaking process. The results of the BOF slag reaction test on a batch fluidization and reaction test facility indicated that the methane conversion rate increased with an increase in the methane concentrations and the reaction temperature. As methane concentration increased from 5 to 15 v/v % at the reaction temperature of 950 °C and the fluidized velocity of 5.1 times the minimum fluidized velocity of BOF slag, the methane conversion rate increased from 65.8 to 76.6%. By setting 10 v/v % as the referenced methane concentration, the methane conversion rate corresponded to 71.6%, and as the reaction temperature increased to 980 °C, the methane conversion rate of 85.7% was achieved. The fluidized gas velocity influenced the fluidized state of the oxygen carrier and the gas residence time in the reactor. As the gas velocity was 1.9 times the minimum fluidization velocity of BOF, the methane and oxygen carrier conversion rates reached 83.3 and 13.0% at the referenced methane concentration and reaction temperature of 950 °C. The experimental results could offer the required design and operation parameters for the methane fluidized bed chemical looping system using BOF slag as the oxygen carrier.
- 5 February 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (3) , 3660-3667
Study of an Iron-Based Oxygen Carrier on the Moving Bed Chemical Looping System
- 5 February 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (3) , 3660-3667
Study of an Iron-Based Oxygen Carrier on the Moving Bed Chemical Looping System
- 1 October 2006
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 44 (10) , 2259-2266
Optical Observation for the Impingements of Nitrogen Tetroxide/Monomethylhydrazine Simulants
- 1 October 2006
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 44 (10) , 2259-2266
Optical Observation for the Impingements of Nitrogen Tetroxide/Monomethylhydrazine Simulants