Effect of cold deformation in quench and tempered medium-carbon steel bars microstructure
- 18 February 2022
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 38 (4) , 230-236
Abstract
Tempered AISI 4140 steel bars were processed by cold drawing. An effective deformation of ≈0.9 was achieved. The quench and tempered, and the subsequently deformed microstructures were analysed by optical and transmission electron microscopy. Intralath, interlath and spherically shaped carbides were identified in both cases. The deformed specimens revealed a mixed structure of thinned laths and dislocations cell-blocks composed of cell-block and cell boundaries. After the deformation process, alignment and fragmentation of the carbides occurred, mainly of those located in lath boundaries what would explain the partial preservation of the lath boundaries after drawing as they would arrest the destruction of lath martensite boundaries. These microstructural characteristics shall play an important role to enhance grain refinement in subsequent heat treatments.Keywords
This publication has 29 references indexed in Scilit:
- Producing the nano/ultrafine grained low carbon steel by martensite process using plane strain compressionJournal of Materials Processing Technology, 2011
- Comparison of Deformation Structure of Lath Martensite in Low Carbon and Ultra-Low Carbon SteelsMaterials Science Forum, 2007
- Work Hardening Behavior of Low Carbon Martensitic SteelKey Engineering Materials, 2007
- Ultrafine Ferrite Grains Produced by Tempering Cold-rolled Martensite in Low Carbon and Microalloyed SteelsISIJ International, 2007
- Ultrafine grained ferrite–martensite dual phase steels fabricated via equal channel angular pressing: Microstructure and tensile propertiesActa Materialia, 2005
- Effect of rolling reduction on ultrafine grained structure and mechanical properties of low-carbon steel thermomechanically processed from martensite starting structureScience and Technology of Advanced Materials, 2004
- Nanoscopic measurement of local plastic deformation for a tempered martensitic steel by atomic force microscopyMaterials Letters, 2003
- Ultragrain refinement of plain low carbon steel by cold-rolling and annealing of martensiteActa Materialia, 2002
- Mechanical properties of ultra fine grained steelsJournal of Materials Processing Technology, 2001
- Ultra-fine austenite grain steel produced by thermomechanical processingScripta Metallurgica, 1988