The influence of non-vacuum electron-beam facing on the structure of Ti-Ta layers formed on the surface of VT1-0 alloy
Open Access
- 20 April 2016
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 124 (1) , 012117
Abstract
The influence of electron-beam facing modes on the structure of Ti-Ta layers formed on the surface of commercially pure titanium VT1-0 has been studied in the paper. The mode of the electron-beam treatment of alloying powder mixture, by which there were no defects in the pad, has been identified. The methods of optical microscopy and scanning electron microscopy have shown that in pads there is dendritic segregation typical for the process of initial crystallisation. At greater magnifications it is possible to observe a structure of the laminar type. The X-ray phase analysis of titanium-tantalum layers justifies the presence of two phases: a hexagonal α'-phase and a cubic (β-phase of titanium.Keywords
This publication has 12 references indexed in Scilit:
- Structure and properties of titanium surface layers after electron beam alloying with powder mixtures containing carbonApplied Surface Science, 2015
- Structure and Properties of Surface Layers Obtained by Atmospheric Electron Beam Cladding of Graphite-Titanium Powder Mixture onto Titanium SubstrateAdvanced Materials Research, 2014
- Corrosion Resistance of Multilayer Ti-Ta Coatings Obtained by Electron Beam Cladding in the AtmosphereAdvanced Materials Research, 2014
- Atmospheric electron-beam surface alloying of titanium with tantalumMaterials Science and Engineering: A, 2013
- Structure of the oxide film on Ti–6Ta alloy after immersion test in 8mol/L boiling nitric acid mediumJournal of Electron Spectroscopy and Related Phenomena, 2013
- Effect of heat treatment on the corrosion behaviour of Ti–5Ta–1.8Nb alloy in boiling concentrated nitric acidJournal of Nuclear Materials, 2008
- Influence of concentration and temperature on the corrosion behavior of titanium, titanium-20 and 40% tantalum alloys and tantalum in sulfuric acid solutionsMaterials Chemistry and Physics, 2007
- High corrosion resistant Ti–5%Ta–1.8%Nb alloy for fuel reprocessing applicationJournal of Nuclear Materials, 2003
- Titanium and Titanium Alloys2003
- Preparation and characterization of Ti–Ta alloys for application in corrosive mediaMaterials Letters, 2003