Power Consumption Optimization in CNC Turning Process Using Multi Objective Genetic Algorithm
- 8 October 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 576, 95-98
Abstract
Power consumption cost is one of the main integral parts of the total machining cost, but it has not given the proper attention when minimizing the machining cost. In this paper, the optimal machining parameters for continuous machining are determined with respect to the minimum power consumption cost with maintaining the surface roughness in the range of acceptance. The constraints considered in this research are cutting speed, feed rate, depth of cut and rake angle. Due to complexity of this machining optimization problem, a multi objective genetic algorithm (MOGA) was applied to resolve the problem, and the results have been analyzed.Keywords
This publication has 9 references indexed in Scilit:
- Energy Cost Modeling for High Speed Hard TurningJournal of Applied Sciences, 2011
- Machining Time Simulation in High Speed Hard TurningAdvanced Materials Research, 2011
- Development of Surface Roughness Prediction Model for High Speed End Milling of Hardened Tool SteelAsian Journal of Scientific Research, 2011
- Particle swarm optimization technique for determining optimal machining parameters of different work piece materials in turning operationThe International Journal of Advanced Manufacturing Technology, 2010
- Optimization of multi-pass turning economies through a hybrid particle swarm optimization techniqueThe International Journal of Advanced Manufacturing Technology, 2010
- Optimization of turning process parameters using Multi-objective Evolutionary algorithm2010
- Response Ant Colony Optimization of End Milling Surface RoughnessSensors, 2010
- Thermodynamic Analysis of Resources Used in Manufacturing ProcessesEnvironmental Science & Technology, 2009
- Optimizing power consumption for CNC turned parts using response surface methodology and Taguchi's technique—A comparative analysisJournal of Materials Processing Technology, 2008