Synergistic Defect Management for Boosting the Efficiency of Cu(In,Ga)Se2 Solar Cells
Open Access
Abstract
In this study, a feasible strategy is proposed for directly depositing high-quality Cu(In,Ga)Se2 (CIGS) films using Na-doped targets in a selenium-free atmosphere to boost the power conversion efficiency (PCE) of CIGS solar cells. Introducing a small amount of sodium dopant effectively promoted the textured growth of CIGS crystals in the prepared films, resulting in larger grain sizes and a smoother interface. The higher MoSe2 content at the CIGS/Mo interface increased the carrier lifetime in the films. In addition, sodium doping increased the proportion of Se atoms on the film surface and reduced the concentration of defects caused by the direct sputtering of the films in the selenium-free atmosphere. Therefore, the separation and transportation of photo-generated carriers in the devices were effectively enhanced. Using the optimized parameters, a record-high PCE of 17.26% was achieved for the 7.5% Na-doped devices, which represents an improvement of nearly 63%.Keywords
Funding Information
- National Key R&D Program of China (2018YFBI150050302, F2018201058, F2022201061, 62204074, 521100221085, CXZZBS2019031, 2018BEB04027)
- Natural Science Foundation of Hebei Province (2018YFBI150050302, F2018201058, F2022201061, 62204074, 521100221085, CXZZBS2019031, 2018BEB04027)
- National Natural Science Foundation of China (2018YFBI150050302, F2018201058, F2022201061, 62204074, 521100221085, CXZZBS2019031, 2018BEB04027)
- Hebei University (2018YFBI150050302, F2018201058, F2022201061, 62204074, 521100221085, CXZZBS2019031, 2018BEB04027)
- Postgraduate’s Innovation Fund Project of Hebei Province (2018YFBI150050302, F2018201058, F2022201061, 62204074, 521100221085, CXZZBS2019031, 2018BEB04027)
- Ningxia Important Research and Development Project (Talent Introduction Project) (2018YFBI150050302, F2018201058, F2022201061, 62204074, 521100221085, CXZZBS2019031, 2018BEB04027)
This publication has 35 references indexed in Scilit:
- Cu(In,Ga)Se2solar cell with 16.7% active-area efficiency achieved by sputtering from a quaternary targetPhysica Status Solidi (a), 2015
- Na‐induced efficiency boost for Se‐deficient Cu(In,Ga)Se2 solar cellsProgress in Photovoltaics: Research and Applications, 2015
- Influence of Ni and Cr impurities on the electronic properties of Cu(In,Ga)Se2thin film solar cellsProgress in Photovoltaics: Research and Applications, 2014
- Influence of iron on defect concentrations and device performance for Cu(In,Ga)Se2 solar cells on stainless steel substratesProgress in Photovoltaics: Research and Applications, 2012
- Determining factor of MoSe2 formation in Cu(In,Ga)Se2 solar CellsSolar Energy Materials and Solar Cells, 2012
- Preferred orientation of Cu(In,Ga)Se2 thin film deposited on stainless steel substrateProgress in Photovoltaics: Research and Applications, 2012
- Alkali incorporation control in Cu(In,Ga)Se2 thin films using silicate thin layers and applications in enhancing flexible solar cell efficiencyApplied Physics Letters, 2008
- In situ investigation of the formation of Cu(In,Ga)Se2 from selenised metallic precursors by X-ray diffraction—The impact of Gallium, Sodium and Selenium excessJournal of Physics and Chemistry of Solids, 2005
- A comparative study of defect states in evaporated and selenized CIGS(S) solar cellsProgress in Photovoltaics: Research and Applications, 2005
- Effects of NaF coevaporation on structural properties of Cu(In,Ga)Se2 thin filmsThin Solid Films, 2003