Experimental study of closed‐loop thermosyphon with a different evaporator geometry
Authors:
- 31 July 2020
- journal article
- research article
- Published by Wiley in Heat Transfer
- Vol. 50 (1) , 466-486
Abstract
In this study, the effect of evaporator geometry on the loop thermosyphon's heat transfer coefficient is experimentally verified by using water as a working fluid with three filling ratios (50%, 70%, 90%), constant heat input (185 W), and condenser cooling water flow rate remaining constant at 2 Lpm. Three evaporator pipes are used (I: straight; II: helical coil evaporator with a diameter of 100‐mm coil and two turns; III: helical coil evaporator with a diameter of 50‐mm coil and four turns). From the experimental results, it can be observed that the performance of evaporator III is higher than the two other forms. A greater heat transfer coefficient value is found in case of type III evaporator and is equivalent to 2456 W/m2·°C. The maximum thermal resistance reduction occurs in the type III evaporator (37.32%), and the highest effective thermal conductivity for the same type is 6.123e + 05 W/m·°C. The experimental results demonstrate good agreement with the empirical equations.Keywords
This publication has 33 references indexed in Scilit:
- Applicability of Uniform Heat Flux Nusselt Number Correlations to Thermosyphon Heat Exchangers for Solar Water HeatersJournal of Solar Energy Engineering, 1999
- Heat transfer and fluid flow studies in the collector tubes of a closed-loop natural circulation solar water heaterEnergy Conversion and Management, 1997
- A Performance Test Method of Solar Thermosyphon SystemsJournal of Solar Energy Engineering, 1991
- An Experimental Study of Natural Convection in a Toroidal LoopJournal of Heat Transfer, 1988
- A three-dimensional analysis of natural convection in a toroidal loop—the effect of Grashof numberInternational Journal of Heat and Mass Transfer, 1987
- A simulation method for solar thermosyphon collectorSolar Energy, 1985
- A review of natural circulation loops in pressurized water reactors and other systemsNuclear Engineering and Design, 1982
- Detailed Loop Model (DLM) analysis of liquid solar thermosiphons with heat exchangersSolar Energy, 1981
- Open-Loop Thermosyphons with Geological ApplicationsJournal of Heat Transfer, 1979
- Thermosyphon Models for Downhole Heat Exchanger Applications in Shallow Geothermal SystemsJournal of Heat Transfer, 1978