Vibration Characteristic Measurement Method of MEMS Gyroscopes in Vacuum, High and Low Temperature Environment and Verification of Excitation Method
Authors:
Open Access
- 10 September 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 129582-129593
Abstract
A method for measuring vibration characteristics of MEMS (Micro Electro Mechanical System) is presented. This method aims to simulate a real environment where MEMS operates. At first, the method of applying high and low temperature in a vacuum environment is studied. And the excitation method applying to movable microstructures of MEMS in this environment is found. Based on the above environmental conditions, the vibration characteristics of MEMS movable microstructure are measured by micro-laser vibration measurement. The base excitation method is used to measure the vibration characteristics of MEMS movable microstructures outside the plane. ANSYS 14.0 was used for finite element simulation to verify this method. The electrostatic excitation method is used to measure the inside of the plane. The stroboscopic method is used to verify the electrostatic excitation by fitting the displacement signal of the movable microstructure and the excitation output signal. The results show that the out-of-plane first-order frequency is 11.926 kHz, and the error is 0.30% compared with the experimental results. The amplitude is 44.218 nm, and the error is 0.59%. The in-plane first-order frequency is 5715.7Hz, which achieves the requirement of design precision. Both the numerical simulation and the stroboscopic method verify the excitation method well. The effect of temperature on the natural frequency of the structure is negatively correlated. And as the temperature drops, the motion of the structure becomes increasingly violent. The findings of this study provide important guidance for maintenance, reliable operation and optimal design of MEMS.Keywords
Funding Information
- National Key Research and Development Program of China (2020YFB2008900)
- Ministry of Education (MOE) Key Laboratory of Disaster Forecast and Control in Engineering, Jinan University (20200904010)
This publication has 23 references indexed in Scilit:
- Researched on the bias stability of the HRG affected by the temperature and the standing wave azimuthMeasurement and Control, 2020
- A Novel Compensation Method for Eliminating Precession Angular-Rate Bias in MEMS Rate-Integrating GyroscopesIEEE Access, 2020
- On dynamic instability of magnetically embedded viscoelastic porous FG nanobeamInternational Journal of Engineering Science, 2019
- Longitudinal vibration responses of axially functionally graded optimized MEMS gyroscope using Rayleigh–Ritz method, determination of discernible patterns and chaotic regimesSN Applied Sciences, 2019
- MEMS Gyroscope Temperature Compensation Based on Drive Mode Vibration Characteristic ControlMicromachines, 2019
- Effect of Uneven Electrostatic Forces on the Dynamic Characteristics of Capacitive Hemispherical Resonator GyroscopesSensors, 2019
- Temperature Energy Influence Compensation for MEMS Vibration Gyroscope Based on RBF NN‐GA‐KF MethodShock and Vibration, 2018
- On the analysis of microbeamsInternational Journal of Engineering Science, 2017
- Microscale Glass-Blown Three-Dimensional Spherical Shell ResonatorsJournal of Microelectromechanical Systems, 2011
- The development of micro-gyroscope technologyJournal of Micromechanics and Microengineering, 2009