Experimental investigation of the modified butterfly notch shear specimen with PMCs
- 25 March 2022
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 56 (11) , 1677-1691
Abstract
An experimental study of the modified butterfly shear sample was undertaken for polymer matrix composites using three quasi-isotropic IM7/977-3 laminates. This study used 3D digital image correlation (DIC) to observe and quantify the severe shear strain concentrations developed by compressively loading the modified butterfly geometry laminates. Interrupted X-Ray computed tomography (X-Ray CT) was used to understand the failure mechanisms present in the region of shear strain. By choosing to conduct interrupted testing, the progressive nature of the damage could be observed. At ultimate failure, extensive damage in the region of high shear strain was observed using post testing inspection with X-Ray CT. The mechanical testing was accompanied by numerical simulations for each laminate. The damage predicted by the numerical simulations was shown to be consistent with the damage observed with the post failure inspection via X-Ray CT. Stress components caused by free-edge effects were also quantified, and shown to have a minimal impact on the failure mode in the region of interest.Keywords
Funding Information
- Air Force Research Laboratory
This publication has 28 references indexed in Scilit:
- A survey of test methods for multiaxial and out-of-plane strength of composite laminatesComposites Science and Technology, 2011
- Interlaminar shear properties of polymer matrix composites: Strain rate effectMechanics of Materials, 2007
- Evaluation of different lap-shear joint geometries for automotive applicationsInternational Journal of Adhesion and Adhesives, 2007
- Tuning the Mechanical Properties of SWNT/Nylon 6,10 Composites with Flexible Spacers at the InterfaceNano Letters, 2007
- The V-Notched Rail Shear TestJournal of Composite Materials, 2007
- Mechanical and physical properties of epoxy composites reinforced by vapor grown carbon nanofibersCarbon, 2005
- On fracture locus in the equivalent strain and stress triaxiality spaceInternational Journal of Mechanical Sciences, 2004
- Evaluation of three in-plane shear test methods for advanced composite materialsComposites, 1990
- Evaluation of in-plane shear test methods for advanced composite materials by the decision analysis techniqueComposites, 1986
- On the Off-Axis Strength Test for Anisotropic Materials1Journal of Composite Materials, 1973