ANALYSIS AND OPTIMIZATION OF VAPOR ABSORPTION GENERATOR-HEAT EXCHANGER USING KERN METHOD AND CFD
- 1 July 2020
- journal article
- research article
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 6 (4) , 440-459
Abstract
The growing demand for new and eco-friendly energy resources has raised the need of sustainable sources or renewable energy for use in present era. A vapor absorption refrigeration system (VARS or VAS) is a closed loop refrigeration system which requires low heat for its functioning and, it is therefore, considered an eco-friendly solution. Since, generator is the main component of VAS which can significantly influence the efficacy of overall system, the current paper involves modeling and thermal analysis of generator using Computational Fluid Dynamics (CFD). The objective of this study is to optimize the heat transfer by changing baffle spacing of generator heat exchanger, running on a single effect LiBr/ water absorption cycle. For this purpose, hot water driven generator of 1ton capacity is taken. The simulation results of CFD were validated by comparing them with theoretical results. The overall design estimation and design technique that follows Birmingham Wire Gauge (BWG) and Tubular Exchangers Manufacturers Association (TEMA) standard are considered in this study. It was found from the analysis that the design model with smallest baffle spacing has the highest heat transfer coefficient. On reducing the baffle spacing from 137mm to 101mm, an increment of 48% in overall heat transfer coefficient was observed. Likewise, an increase in velocity by 36% and drop in static pressure by 27% were seen. Similar trend was observed in the theoretical results.Keywords
This publication has 21 references indexed in Scilit:
- Numerical Analysis of Energy Storage Systems Using Two Phase-Change Materials with NanoparticlesJournal of Thermophysics and Heat Transfer, 2018
- Mathematical modelling and simulation of a solar water heater for an aviculture unit using MATLAB/SIMULINKJournal of Renewable and Sustainable Energy, 2017
- Simulation and optimization of a solar-assisted heating and cooling system for a house in Northern of IranJournal of Renewable and Sustainable Energy, 2017
- Experimental analysis to improving thermosyphon (TPCT) thermal efficiency using nanoparticles/based fluids (water)The European Physical Journal Plus, 2017
- Pool boiling heat transfer to dilute copper oxide aqueous nanofluidsInternational Journal of Thermal Sciences, 2015
- Modeling water/lithium bromide absorption chillers in ASPEN PlusApplied Energy, 2011
- Pool boiling of nanofluids: Comprehensive review of existing data and limited new dataInternational Journal of Heat and Mass Transfer, 2009
- Numerical study for enhancing the thermal conductivity of phase change material (PCM) storage using high thermal conductivity porous matrixEnergy Conversion and Management, 2005
- Design and construction of a LiBr–water absorption machineEnergy Conversion and Management, 2003
- A review of absorption refrigeration technologiesRenewable and Sustainable Energy Reviews, 2001