Effect of Voltage on Platinum Dissolution
- 1 January 2006
- journal article
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 9 (5) , A225-A227
Abstract
One of the processes responsible for performance degradation of a polymer electrolyte fuel cell (PEFC) is the loss of the electrochemically active surface area of the platinum-based electrocatalysts, due in part to platinum dissolution. The long-term dissolution behavior of polycrystalline platinum and high-surface-area carbon-supported platinum particles was studied under potentiostatic conditions relevant to PEFC cathode conditions. The equilibrium concentration of dissolved Pt was found to increase monotonically from 0.65 to (vs SHE) and decrease at potentials . Dissolution rates measured at were comparable for the two types of electrodes (1.4 and ).Keywords
This publication has 17 references indexed in Scilit:
- Nafion∕TiO[sub 2] Proton Conductive Composite Membranes for PEMFCs Operating at Elevated Temperature and Reduced Relative HumidityJournal of the Electrochemical Society, 2005
- Instability of Pt∕C Electrocatalysts in Proton Exchange Membrane Fuel CellsJournal of the Electrochemical Society, 2005
- Alteration of the distribution of the platinum catalyst in membrane-electrode assemblies during PEFC operationJournal of Power Sources, 2004
- Extent of PEMFC Cathode Surface Oxidation by Oxygen and Water Measured by CVElectrochemical and Solid-State Letters, 2004
- Kinetic Model of Platinum Dissolution in PEMFCsJournal of the Electrochemical Society, 2003
- Applications of surface X-ray scattering to electrochemistry problemsElectrochimica Acta, 2002
- Surface Area Loss of Supported Platinum in Polymer Electrolyte Fuel CellsJournal of the Electrochemical Society, 1993
- Agglomeration of Platinum Particles Supported on Carbon in Phosphoric AcidJournal of the Electrochemical Society, 1988
- Platinum Dissolution in Concentrated Phosphoric AcidJournal of the Electrochemical Society, 1979
- A ring-disk electrode study of the current/potential behaviour of platinum in 1.0 M sulphuric and 0.1 M perchloric acidsElectrochimica Acta, 1970