Quality Factor Extraction and Enhancement Across Temperature in Ring Resonators
- 10 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 29 (5) , 1124-1126
Abstract
This work demonstrates that thin slots strategically placed in MEMS ring resonators are able to enhance the quality factor (Q) of the device operated in a wineglass mode in the isothermal region. The devices are optimized using COMSOL for an increased Q through increased slot size, using the Zener curve as a comparative baseline. These parts are fabricated and encapsulated in an ultra-clean environment, and tested in various temperature and pressure conditions to directly measure changes in anchor, gas, and thermoelastic dissipation across temperature. [2020-0156]Keywords
Funding Information
- Defense Advanced Research Projects Agency (DARPA) grant “Precise Robust Inertial Guidance for Munitions (PRIGM)”, managed by Dr. Ron Polcawich (N66001-16-1-4023)
- National Science Foundation, at the Stanford Nanofabrication Facility (ECS- 9731293)
This publication has 9 references indexed in Scilit:
- Direct Detection of Akhiezer Damping in a Silicon MEMS ResonatorScientific Reports, 2019
- Topology optimization for reduction of thermo-elastic dissipation in MEMS resonators2017
- Manipulation of heat flux paths in thermo-elastically damped resonators for Q optimization2017
- An investigation on thermoelastic damping of high-Q ring resonatorsInternational Journal of Mechanical Sciences, 2016
- Multimode thermoelastic dissipationJournal of Applied Physics, 2009
- Impact of Geometry on Thermoelastic Dissipation in Micromechanical Resonant BeamsJournal of Microelectromechanical Systems, 2006
- A preliminary investigation of thermo-elastic damping in silicon ringsJournal of Micromechanics and Microengineering, 2004
- Internal Friction in Solids II. General Theory of Thermoelastic Internal FrictionPhysical Review B, 1938
- Internal Friction in Solids. I. Theory of Internal Friction in ReedsPhysical Review B, 1937