The Effect of Mechanical Varus on Anterior Cruciate Ligament and Lateral Collateral Ligament Stress: Finite Element Analyses
Authors:
- Betina B. HinckelBHBetina B. Hinckel
- Marco K. DemangeMDMarco K. Demange
- Riccardo G. GobbiRGRiccardo G. Gobbi
- José Ricardo PécoraJPJosé Ricardo Pécora
- Gilberto Luis CamanhoGCGilberto Luis Camanho
- 1 July 2016
- journal article
- Published by SLACK, Inc. in Orthopedics
- Vol. 39 (4) , e729-36
Abstract
The current study analyzed changes in anterior cruciate ligament (ACL) and lateral collateral ligament stress as a result of mechanical varus. In an exploratory pilot study, progressive mechanical varus was introduced to a male finite element model of the lower limb at different knee flexion angles. Nine situations were analyzed (combinations of 0°, 30°, and 60° knee flexion and 0°, 5°, and 10° varus). The ACL stress was measured via changes in section force, von Mises stress, and fiber stress. Lateral collateral ligament stress was measured via changes in section force. For all 3 measures of the ACL, maximum stress values were found in extension, stress decreased with flexion, and the effect of varus introduction was most significant at 30° flexion. With 60° flexion, varus introduction produced a decrease in section force and von Mises stress and a small increase in fiber stress. In all situations and stress measures except fiber stress at 60° flexion, stress was concentrated at the posterolateral bundle. For the lateral collateral ligament, the introduction of 5° and 10° varus caused an increase in section force at all degrees of flexion. Stress in the ligament decreased with flexion. Mechanical varus of less than 10° was responsible for increased ACL stress, particularly at 0° and 30° knee flexion, and for increased lateral collateral ligament stress at all degrees of flexion. Stress was mostly concentrated on the posterolateral bundle of the ACL. [ Orthopedics. 2016; 39(4):e729–e736.]Keywords
This publication has 40 references indexed in Scilit:
- Applications of finite element simulation in orthopedic and trauma surgeryWorld Journal of Orthopedics, 2012
- The application of muscle wrapping to voxel-based finite element models of skeletal structuresBiomechanics and Modeling in Mechanobiology, 2011
- The effect of isolated popliteus tendon complex injury on graft force in anterior cruciate ligament reconstructed kneesInternational Orthopaedics, 2010
- Automated muscle wrapping using finite element contact detectionJournal of Biomechanics, 2010
- Protocol for constructing subject-specific biomechanical models of knee jointComputer Methods in Biomechanics and Biomedical Engineering, 2010
- A Study on Construction Three-Dimensional Nonlinear Finite Element Model and Stress Distribution Analysis of Anterior Cruciate LigamentJournal of Biomechanical Engineering, 2009
- The mechanical consequences of dynamic frontal plane limb alignment for non-contact ACL injuryJournal of Biomechanics, 2006
- Structural properties of the medial collateral ligament complex of the human kneeJournal of Biomechanics, 2005
- Evaluation of the effect of joint constraints on the in situ force distribution in the anterior cruciate ligamentJournal of Orthopaedic Research, 1997
- The anterior cruciate ligament-deficient knee with varus alignmentThe American Journal of Sports Medicine, 1992