Electrospun PVDF/SiO 2 Separators for High‐Performance Lithium‐Ion Batteries
Open Access
- 1 January 2026
- journal article
- Published by Wiley in International Journal of Energy Research
- Vol. 2026 (1)
Abstract
The performance and safety of lithium‐ion batteries (LIBs) are strongly influenced by the properties of the separator, which must simultaneously ensure efficient ion transport, high electrolyte affinity, electrochemical stability, and adequate mechanical integrity. However, achieving a balanced combination of these properties remains challenging, particularly for polymer‐based separators. In this work, electrospun PVDF/SiO 2 nanofibrous membranes were fabricated and systematically evaluated as LIB separators, with specific attention to the effect of SiO 2 content on the structural and electrochemical characteristics. Among the prepared samples, the PVDF separator containing 10 wt% SiO 2 exhibited the most favorable balance of properties. This membrane features a uniform nanofibrous morphology with an average fiber diameter of ~310 nm, a high porosity of 66%, and an exceptional electrolyte uptake (EU) of 375%, which collectively promote efficient electrolyte retention and ion transport. Consequently, a high ionic conductivity of 1.99 mS cm −1 was achieved while maintaining acceptable mechanical properties, including a tensile strength of 1.36 MPa and an elongation at break of 39%. Linear sweep voltammetry (LSV) measurements revealed an extended electrochemical stability window up to ~5.0 V, indicating enhanced oxidation resistance. When employed in Li/LiFePO 4 half‐cells, the optimized separator delivered stable long‐term cycling performance, retaining a discharge capacity of about 100 mAh g −1 after 250 cycles with ~80% capacity retention and a Coulombic efficiency close to 100%. In addition, the cell assembled with the PVDF + 10 wt% SiO 2 separator exhibited better rate capability, delivering a discharge capacity of about 77 mAh g −1 at 2 C and maintaining about 103 mAh g −1 after 100 cycles at 1C. The results demonstrate that rational incorporation of SiO 2 nanoparticles into electrospun PVDF separators can effectively balance porosity, electrolyte wettability, ionic conductivity, and electrochemical stability, offering a simple and practical strategy for developing high‐performance separators for advanced LIBs.Keywords
This publication has 49 references indexed in Scilit:
- Novel fibrous composites based on electrospun PSF and PVDF ultrathin fibers reinforced with inorganic nanoparticles: Evaluation as oil spill sorbentsPolymers for Advanced Technologies, 2018
- Mechanically Reinforced PVdF/PMMA/SiO2 Composite Membrane and Its Electrochemical Properties as a Separator in Lithium‐Ion BatteriesEnergy Technology, 2017
- A Thermally Stable, Combustion‐Resistant, and Highly Ion‐Conductive Separator for Lithium‐Ion Batteries Based on Electrospun Fiber Mats of Crosslinked PolybenzoxazineEnergy Technology, 2016
- Preparation and characterization of electrospun nanofiber-coated membrane separators for lithium-ion batteriesJournal of Solid State Electrochemistry, 2014
- Fabrication and characterization of SiO2/PVDF composite nanofiber‐coated PP nonwoven separators for lithium‐ion batteriesJournal of Polymer Science Part B: Polymer Physics, 2013
- Preparation and properties of nanofiber-coated composite membranes as battery separators via electrospinningJournal of Materials Science, 2012
- Poly(vinylidene fluoride)/silica nanocomposite membranes by electrospinningJournal of Applied Polymer Science, 2012
- On the electrospinning of PVDF: influence of the experimental conditions on the nanofiber propertiesPolymer International, 2012
- PVDF–TiO2 composite hollow fiber ultrafiltration membranes prepared by TiO2 sol–gel method and blending methodJournal of Applied Polymer Science, 2009
- The morphological evolution, mechanical properties and ionic conductivities of electrospinning P(VDF-HFP) membranes at various temperaturesIonics, 2009