Mechanical behavior of single-lap and double-lap adhesive joined composite parts
- 15 November 2017
- journal article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 59 (11-12) , 1019-1026
Abstract
The composite parts bonded with embedded single lap joint (SLJ) subjected to tensile load were analyzed previously. The embedded adhesive was applied between two composite parts and the mechanical behavior of the joint was examined. In this study, composite parts bonded with single-lap joint (SLJ) and double-lap joint (DLJ) subjected to tensile load were analyzed by using 3D finite element method (FEM). The advantages of two different joint methods were investigated. In the analysis, the composite parts were carbon/epoxy (AS4/3501-6) with different fiber orientation angles and the adhesive was DP 410. The models for the numerical analyses were generated by using the ANSYS software package. The finite element analyses (FEA) were carried out to predict the failure loads. Stress in x-, y-, z-directions, shear stresses and the von-Mises stresses on adhesive were obtained at time of failure for predetermined parameters. Consequently, the effects of orientation angles, overlap dimensions and joining methods were examined. The most effective parameters and joining process were determined for composite parts with single-lap and double-lap joints.Keywords
This publication has 22 references indexed in Scilit:
- Mechanical testing and analysis of composite parts adhesively joined under tensile loadMaterials Testing, 2017
- Enhanced elastic-foundation analysis of balanced single lap adhesive jointsInternational Journal of Adhesion and Adhesives, 2017
- Theoretical model of adhesively bonded single lap joints with functionally graded adherendsEngineering Structures, 2016
- An efficient analysis model for functionally graded adhesive single lap jointsInternational Journal of Adhesion and Adhesives, 2016
- Effects of laminate carbon/epoxy composite patches on the strength of double-strap adhesive joints: Experimental and numerical analysisMaterials & Design (1980-2015), 2013
- The effects of partial bonding in load carrying capacity of single lap jointsInternational Journal of Adhesion and Adhesives, 2011
- Mechanical characterization of steel/CFRP double strap joints at elevated temperaturesComposite Structures, 2011
- Bond–slip models for double strap joints strengthened by CFRPComposite Structures, 2010
- On joint strengths, peel stresses and failure modes in adhesively bonded double-strap and supported single-lap GFRP jointsComposite Structures, 2009
- Experimental and finite element analysis of a double strap joint between steel plates and normal modulus CFRPComposite Structures, 2006