Low cost, contamination-free, and damage-free fabrication of PZT MEMS on SOI substrate
- 28 December 2021
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 32 (2) , 025003
Abstract
This paper reports a generalised process flow for the fabrication of lead zirconate titanate based piezoelectric micro electromechanical system devices. The optimised process can be used to realise several devices with different 1D and 2D geometries on a single wafer. All the state-of-the-art fabrication methods introduce some damage to the active piezoelectric material. This damage entails the need for an additional step of recovery anneal in the fabrication process. Our process was designed and optimised to avoid any such damage to the Lead Zirconate Titanate (PZT) layer. Remnant polarisation and effective transverse piezoelectric coefficient ( e 31, f ) were used as metrics to quantify the damage to the PZT layer. It is shown that our process does not damage the PZT thin film during the fabrication, and hence no recovery anneal is required. We observe a ∼3× improvement in remnant polarisation and ∼2× improvement in e 31, f of PZT thin film compared to the PZT thin film subjected to our previous fabrication process. Moreover, the process explained here uses only wet chemical methods for patterning of contaminating agents (PZT and platinum), making it a cost-effective process.Keywords
Funding Information
- DRDO
This publication has 42 references indexed in Scilit:
- A new S-shaped MEMS PZT cantilever for energy harvesting from low frequency vibrations below 30 HzMicrosystem Technologies, 2012
- A PIEZOELECTRICALLY ACTUATED MEMS SPEAKER WITH POLYIMIDE MEMBRANE AND THIN FILM Pb(Zr,Ti)O3(PZT) ACTUATORIntegrated Ferroelectrics, 2009
- THIN-FILM PIEZOELECTRIC ACTUATORS FOR BIO-INSPIRED MICRO-ROBOTIC APPLICATIONSIntegrated Ferroelectrics, 2007
- Simulation of Hydrogen Diffusion and Initiation of Hydrogen‐Induced Cracking in PZT Ferroelectric Ceramics Using a Phase Field ModelJournal of the American Ceramic Society, 2007
- A Novel Wet Etching Process of Pb(Zr,Ti)O3 Thin Films for Applications in Microelectromechanical SystemJapanese Journal of Applied Physics, 2004
- Development of piezoelectric micromachined ultrasonic transducersSensors and Actuators A: Physical, 2004
- Measurement of transverse piezoelectric properties of PZT thin filmsSensors and Actuators A: Physical, 2003
- Surface micromachined piezoelectric accelerometers (PiXLs)Journal of Microelectromechanical Systems, 2001
- Degradation of Ferroelectric Pb(Zr,Ti)O3 Under Reducing ConditionsMRS Proceedings, 2000
- Electrode-induced degradation of Pb(ZrxTi1−x)O3 (PZT) polarization hysteresis characteristics in Pt/PZT/Pt ferroelectric thin-film capacitorsApplied Physics Letters, 1996