Air-Side Heat Transfer Performance of Louver Fin and Multitube Heat Exchanger for Direct Methanol Fuel Cell Cooling Application
- 13 March 2014
- journal article
- Published by ASME International in Journal of Fuel Cell Science and Technology
- Vol. 11 (4) , 041004
Abstract
The present work is performed to evaluate the heat transfer performance of a heat exchanger used in a direct methanol fuel cell. Because of material constraints and performance requirements, a louver fin heat exchanger is modified for use with conventional microchannel tubes and also with multiple small-diameter tubes (called multitubes). Prototype heat exchangers are tested, and the air-side heat transfer, pressure drop, and fan power are measured in a wind tunnel and simulated using a commercial code. The air-side pressure drop and heat transfer coefficient of the multitubes show similar trends to those of the flat-tube heat exchanger if the contact resistance is negligible. The tube spacing of the prototype multitube heat exchangers has a small effect on the pressure drop and heat transfer, but it has a profound effect on the air-side heat transfer performance because of the contact resistance between the tubes and louver fins. The air-side pressure drop agrees well with an empirical correlation for flat tubes.Keywords
This publication has 5 references indexed in Scilit:
- Heat Transfer and Flow Resistance Characteristics of Louver Fin Geometry for Automobile ApplicationsJournal of Heat Transfer, 2011
- The Air-Side Thermal-Hydraulic Performance of Flat-Tube Heat Exchangers With Louvered, Wavy, and Plain Fins Under Dry and Wet ConditionsJournal of Heat Transfer, 2009
- PERFORMANCE COMPARISON OF ENHANCED FIN GEOMETRIES USED IN FIN-AND-TUBE HEAT EXCHANGERS1998
- Prediction of Heat Transfer and Friction for the Louver Fin GeometryJournal of Heat Transfer, 1992
- Heat transfer and pressure drop characteristics of flat tube and louvered plate fin surfacesExperimental Thermal and Fluid Science, 1988