Failure characteristics of two porous sandstones subjected to true triaxial stresses: Applied through a novel loading path
Open Access
- 20 March 2017
- journal article
- research article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 122 (4) , 2525-2540
Abstract
We performed an extensive suite of true triaxial experiments in two porous sandstones, Bentheim (porosity ≈ 24%) and Coconino (17%). The experiments were conducted using a novel loading path, which maintains constant Lode angle (Θ) throughout the test. This path enabled the examination of the effects of Lode angle and mean stress on failure (σoct,f). Our tests covered σ3 magnitudes between 0 and 150 MPa and of Θ at −30° (axisymmetric extension), −16°, 0°, +11°, +21°, and +30° (axisymmetric compression). Test results revealed the respective contribution of each of the two stress invariants to failure stress, failure plane angle, and failure mode. In both sandstones, the shear stress required for failure increases with mean stress but decreases with Θ when shear failure mode dominates. However, the dependence of failure stress on mean stress and Θ is reversed when the compactive failure mode is in control. The compactive failure mode was evident in Bentheim sandstone when compaction bands were observed under high mean stress. The Coconino sandstone did not reach the compactive failure regime within the maximum confinement applied. The failure plane angle monotonically decreases with increasing mean stress and Θ. For Coconino sandstone, failure plane angle varies between 80° and 50° for σoct,f between 50 and 450 MPa whereas it drops to 0° as σoct,f, approaches 250 MPa in Bentheim sandstone. We employed the bifurcation theory to relate the stress conditions at failure to the development of failure planes. The theory is in qualitative agreement with the experimental data.Keywords
Funding Information
- National Science Foundation (EAR-0940323)
This publication has 41 references indexed in Scilit:
- Connecting microstructural attributes and permeability from 3D tomographic images of in situ shear-enhanced compaction bands using multiscale computationsGeophysical Research Letters, 2011
- Pure and shear-enhanced compaction bands in Aztec SandstoneJournal of Structural Geology, 2010
- The effect of the intermediate principal stress on fault formation and fault angle in siltstoneJournal of Structural Geology, 2010
- Geological and mathematical framework for failure modes in granular rockJournal of Structural Geology, 2006
- Permeability evolution during localized deformation in Bentheim sandstoneJournal of Geophysical Research, 2004
- Compaction localization and fluid flowJournal of Geophysical Research, 2003
- Dilation bands: A new form of localized failure in granular mediaGeophysical Research Letters, 2002
- Compacting and dilating shear bands in porous rock: Theoretical and experimental conditionsJournal of Geophysical Research, 2001
- Theoretical and experimental investigation of compaction bands in porous rockJournal of Geophysical Research, 1999
- Compaction bands: a structural analog for anti-mode I cracks in aeolian sandstoneTectonophysics, 1996