A Single-Stage 0X/1X Regulating Rectifier With Improved Voltage Mode Delay Compensation for Wirelessly Powered Implantable Medical Devices
Open Access
- 24 June 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 116114-116125
Abstract
This article presents a 6.78 MHz single-stage wireless power transfer receiver (RX) using 0X/1X regulating rectifier with improved voltage mode (VM) delay compensation for implantable medical devices (IMDs). The regulation of 0X/1X modes is achieved through pulse width modulation (PWM), with the frequency set at 1/16 of the carrier clock to ensure circuit stability and enhance power conversion efficiency (PCE) under light loads. VM delay compensation has the advantage of power consumption. However, the traditional VM on-delay compensation may become ineffective because a large voltage pulse will occur on the RX side input when the circuit delays increase. Therefore, an improved VM on-delay compensation method is proposed. Coarse compensation for on-delays can be achieved by reusing the control signal generated from off-delay compensation loop, as off-delay compensation processes will not be influenced by on-delay compensation processes. It allows the on-delay compensation loop to function normally and finely compensate for on-delays. The proposed rectifier is designed in 0.18μm CMOS process. It can achieve output voltage management of 1.8V. Comparing with other regulating rectifier, the proposed rectifier has a fast transient response of 14 μs and a small chip area of 0.91 mm 2 . The simulation results indicate that this rectifier can attain high PCE of 84.6% in light load (500Ω) and peak PCE of 93.5% in heavy load (50Ω). The high voltage conversion ratio (VCR) of over 93% is also achieved under the large circuit delays.Keywords
Funding Information
- Chinese Academy of Sciences Youth Interdisciplinary Team (JCTD-2022-07)
This publication has 26 references indexed in Scilit:
- Structure-Reconfigurable Power Amplifier (SR-PA) and 0X/1X Regulating Rectifier for Adaptive Power Control in Wireless Power Transfer SystemIEEE Journal of Solid-State Circuits, 2021
- A 13.56-MHz Active Rectifier With SAR-Assisted Coarse-Fine Adaptive Digital Delay Compensation for Biomedical Implantable DevicesIEEE Solid-State Circuits Letters, 2020
- A 69.3% Efficiency, 6.78-MHz Wireless Power Delivery System with 0X/1X Regulating Rectifier and Reconfigurable Power Amplifier2019
- Applications of Wireless Power Transfer in Medicine: State-of-the-Art ReviewsAnnals of Biomedical Engineering, 2018
- A 6.78-MHz Single-Stage Wireless Power Receiver Using a 3-Mode Reconfigurable Resonant Regulating RectifierIEEE Journal of Solid-State Circuits, 2017
- A Near-Optimum 13.56 MHz CMOS Active Rectifier With Circuit-Delay Real-Time Calibrations for High-Current Biomedical ImplantsIEEE Journal of Solid-State Circuits, 2016
- Adaptive On/Off Delay-Compensated Active Rectifiers for Wireless Power Transfer SystemsIEEE Journal of Solid-State Circuits, 2016
- A Q-Modulation Technique for Efficient Inductive Power TransmissionIEEE Journal of Solid-State Circuits, 2015
- A 13.56 MHz Wireless Power Transfer System With Reconfigurable Resonant Regulating Rectifier and Wireless Power Control for Implantable Medical DevicesIEEE Journal of Solid-State Circuits, 2015
- A 13.56 MHz 40 mW CMOS High-Efficiency Inductive Link Power Supply Utilizing On-Chip Delay-Compensated Voltage Doubler Rectifier and Multiple LDOs for Implantable Medical DevicesIEEE Journal of Solid-State Circuits, 2014