Tube Drawing Process with Diameter Expansion for Effectively Reducing Thickness
Open Access
Abstract
The present paper describes a tube drawing method with diameter expansion, which is herein referred to as “expansion drawing”, for effectively producing thin-walled tube. In the proposed method, the tube end is flared by pushing a plug into the tube, and the tube is then expanded by drawing the plug in the axial direction while the flared end is chucked. The forming characteristics and effectiveness of the proposed method were investigated through a series of finite element method (FEM) analyses and experiments. As a result of FEM analysis, the expansion drawing effectively reduced the tube thickness with a smaller axial load when compared with the conventional method. According to the experimental results, the thin-walled tube was produced successfully by the expansion drawing. Maximum thickness reduction ratios for a carbon steel (STKM13C) and an aluminum alloy (AA1070) were 0.15 and 0.29 when the maximum expansion ratios were 0.23 and 0.31, respectively. The above results suggest that the proposed expansion drawing method is effective for producing thin-walled tubes.Keywords
Funding Information
- Amada Foundation (AF-2018034)
This publication has 16 references indexed in Scilit:
- Influence of Internal Pressure and Axial Compressive Displacement on the Formability of Small-Diameter ZM21 Magnesium Alloy Tubes in Warm Tube HydroformingMetals, 2020
- Effect of Punch Shape on Multiprocess Tube Flaring for Eccentric PartsJournal of the Japan Society for Technology of Plasticity, 2019
- Optimization of spinning process parameters for long thin-walled cylinder of TC11 alloy based on processing mapThe International Journal of Advanced Manufacturing Technology, 2018
- Dimensional accuracy of tubes in cold pilgeringJournal of Materials Processing Technology, 2016
- Surface roughening analysis of cold drawn tube based on macro–micro coupling finite element methodJournal of Materials Processing Technology, 2015
- Precision tube production: Influencing the eccentricity and residual stresses by tilting and shiftingJournal of Materials Processing Technology, 2015
- Experimental and numerical characterization of a mechanical expansion process for thin-walled tubesJournal of Materials Processing Technology, 2014
- Effect of plug on levelling of residual stress in tube drawingJournal of Materials Processing Technology, 2008
- The influence of the deformation mode on the final mechanical properties of products in multi-pass drawing and flat rollingJournal of Materials Processing Technology, 2002
- Shear spinning technology for manufacture of long thin wall tubes of small boreJournal of Materials Processing Technology, 1995