Design‐oriented analysis of cross‐regulation in single‐inductor dual‐output Buck‐boost DC‐DC converters
- 27 June 2021
- journal article
- research article
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 49 (12) , 3966-3993
Abstract
In single‐inductor multiple‐output converters, the multiplexing of the inductor at each output port will inevitably lead to severe cross‐regulation effect. This paper aims to investigate the steady state performance and transient state cross‐regulation in the single‐inductor multiple‐output DC‐DC converters. A ripple‐based averaged model is proposed to describe the inherent cross‐regulation characteristics of single‐inductor dual‐output (SIDO) Buck‐Boost DC‐DC converter by considering the three piecewise ripple of the inductor current. Then, the steady state performance analysis is carried out to show the cross‐coupling effect on the power distribution relationship and voltage gains of the two output ports. Furthermore, the nonlinear modal series representation is derived to describe the transient behavior of SIDO converter under different load disturbances. More significantly, based on the nonlinear modal analysis, the cross‐regulation factors are proposed to evaluate the influence of some key circuit parameters on the transient state cross‐regulation. It is found that increasing kp2 may improve the transient cross‐regulation performance of the output voltages, but non‐ideal factor VF has little influence on the transient cross‐regulation. This provides much design‐oriented information to suppress the cross‐regulation and optimize the transient performance of the SIDO converter. Finally, the effectiveness of the above analysis is verified by the experimental results. This paper proposes one design‐oriented analysis method to investigate the cross‐regulation in the SIDO DC‐DC converters based on the ripple‐based averaged model. Firstly, the steady state analysis is carried out to show the cross‐coupling effect on the power distribution of the two output ports. Then, according to the nonlinear modal analysis, the cross‐regulation factors are defined to identify the key parameters for the transient cross‐regulation, which provides some design‐oriented information to suppress the cross‐regulation.Keywords
Funding Information
- Natural Science Basic Research Program of Shaanxi Province (2021JM‐014)
- National Natural Science Foundation of China (54177141)
This publication has 32 references indexed in Scilit:
- Investigation of the double input power converter with N stages of voltage multiplier using PSO‐based MPPT technique for the thermoelectric energy harvesting systemInternational Journal of Circuit Theory and Applications, 2020
- Dual-Input Grid-Connected Photovoltaic Inverter With Two Integrated DC–DC Converters and Reduced Conversion StagesIEEE Transactions on Energy Conversion, 2018
- Unified Discrete-Mapping Model and Dynamical Behavior Analysis of Current-Mode Controlled Single-Inductor Dual-Output DC–DC ConverterIEEE Journal of Emerging and Selected Topics in Power Electronics, 2018
- Effect of Circuit Parameters on the Stability and Boundaries of Peak Current Mode Single-Inductor Dual-Output Buck ConvertersIEEE Transactions on Industrial Electronics, 2017
- Single-Phase Six-Switch Dual-Output Inverter Using Dual-Buck StructureIEEE Transactions on Power Electronics, 2017
- Performance and design analysis of an improved non‐isolated multiple input buck DC–DC converterIET Power Electronics, 2017
- Magnetising inductance of multiple‐output flyback dc–dc convertor for discontinuous‐conduction modeIET Power Electronics, 2017
- Analysis, Design, Modeling, and Control of an Interleaved-Boost Full-Bridge Three-Port Converter for Hybrid Renewable Energy SystemsIEEE Transactions on Power Electronics, 2016
- A 400 nW Single-Inductor Dual-Input–Tri-Output DC–DC Buck–Boost Converter With Maximum Power Point Tracking for Indoor Photovoltaic Energy HarvestingIEEE Journal of Solid-State Circuits, 2015
- A Nonisolated Three-Port DC–DC Converter and Three-Domain Control Method for PV-Battery Power SystemsIEEE Transactions on Industrial Electronics, 2015