High‐Strength and ‐Toughness Electroconductive SiC‐Based Composites
- 24 October 2006
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 8 (10) , 997-1001
Abstract
SiC‐based electroconductive composites containing 10 and 30 vol% MoSi2 particles were hot pressed at 1900°C. The MoSi2 particles, besides increasing the electrical conductivity of the silicon carbide matrix, acted as reinforcement for the material. For the composition containing 30 vol% of MoSi2 (see figure), the room‐temperature strength was 825 MPa, the fracture toughness 4.8 MPa·m0.5 and the electrical resistivity 1.3·10–3 Ohm·cm.Keywords
This publication has 20 references indexed in Scilit:
- Improvements Offered by Coprecipitation of Sintering Additives on Ultra‐Fine SiC MaterialsAdvanced Engineering Materials, 2005
- Liquid phase sintering of SiC with additions of Y2O3, Al2O3 and SiO2Journal of the European Ceramic Society, 2004
- High‐Temperature Resistant Composites in the AlN–SiC–MoSi 2 SystemJournal of the American Ceramic Society, 2003
- On the rule of mixtures for the hardness of particle reinforced compositesMaterials Science and Engineering: A, 2000
- Effects of additives on densification, microstructure and properties of liquid-phase sintered silicon carbideJournal of Materials Science, 2000
- Mechanical Behavior of MoSi 2 Reinforced–Si 3 N 4 Matrix CompositesJournal of the American Ceramic Society, 1997
- Progress in silicon-based non-oxide structural ceramicsInternational Journal of Refractory Metals and Hard Materials, 1997
- Liquid phase sintering of silicon carbideJournal of the European Ceramic Society, 1996
- Processing of molybdenum disilicideJournal of Materials Science, 1994
- MoSi2 particle reinforced-SiC and Si3N4 matrix compositesJournal of Materials Science Letters, 1990