Printability of buried extreme ultraviolet lithography photomask defects
- 1 February 2016
- journal article
- Published by SPIE-Intl Soc Optical Eng in Journal of Micro/Nanolithography, MEMS, and MOEMS
- Vol. 15 (2) , 021004
Abstract
Native acting phase-programmed defects, otherwise known as buried program defects, with attributes very similar to native defects, were successfully fabricated using a high-accuracy overlay technique. The defect detectability and visibility were analyzed with conventional amplitude and phase-contrast blank inspection at 193-nm wavelength, pattern inspection at 193-nm wavelength, and scanning electron microscopy. The mask was also printed on wafer, and printability is discussed. Finally, the inspection sensitivity and wafer printability are compared, leading to the observation that the current blank- and pattern-inspection sensitivity is not enough to detect all of the printable defects.Keywords
This publication has 10 references indexed in Scilit:
- Reflecting on inspectability and wafer printability of multiple EUV mask absorbers2013
- Evaluation of non-actinic EUV mask inspection and defect printability on multiple EUV mask absorbers2013
- Exploring probability of shallow ML defect impact to defect assurance2013
- Illuminating extreme ultraviolet lithography mask defect printabilityJournal of Micro/Nanolithography, MEMS, and MOEMS, 2013
- Illuminating EUVL mask defect printability2012
- Impact of EUV photomask line-edge roughness on wafer prints2012
- Novel programmed defect mask blanks for ML defect understanding and characterization2012
- Shedding light on EUV mask inspection2012
- Printability of native blank defects and programmed defects and their stack structures2011
- Fabrication of programmed phase defects on EUV multilayer blanks2003