Fatigue behavior of precipitation strengthened Cu–Ni–Si alloy modified by Cr and Zr addition
- 13 January 2020
- journal article
- research article
- Published by Emerald Publishing in International Journal of Structural Integrity
- Vol. 11 (6) , 861-873
Abstract
Purpose: The purpose of this paper is to investigate the fatigue behavior of precipitation-strengthened Cu‒2.55Ni‒0.55Si alloy, modified by the addition of 0.25 Cr and 0.25 Zr (wt%), using mechanical and fractographical studies to reveal the effect of microstructural features on the fracture.Design/methodology/approach: For strengthening, cast and hot forged alloy was subjected to solution annealing at 900°C for 60 min, followed by quenching in water and then aging at 490°C for 180 min. Precipitation-hardened alloy was exposed to fatigue tests atR=−1 and different stress levels. All fracture surfaces were examined within the frame of fractographical analysis.Findings: Fine Ni-rich silicides responsible for the precipitation strengthening were observed within the matrix and their interactions with the dislocations at lower stress level resulted in localized shearing and fine striations. Although, by the addition of Cr and Zr, the matrix consisted of hard Ni, Zr-rich and Cr-rich silicides, these precipitates adversely affected the fatigue behavior acting as nucleation sites for cracks.Originality/value: These findings contribute to the present knowledge by revealing the effect of microstructural features on the mechanical behavior of precipitation-hardened Cu‒Ni‒Si alloy modified by Cr and Zr addition.Keywords
This publication has 20 references indexed in Scilit:
- Fractographical analysis of fatigue failed Cu–2.55Ni–0.55Si alloyTheoretical and Applied Fracture Mechanics, 2016
- Suppressing spinodal decomposition by adding Co into Cu–Ni–Si alloyJournal of Alloys and Compounds, 2016
- Strengthening of Cu–Ni–Si alloy using high-pressure torsion and agingMaterials Characterization, 2014
- A new ultrahigh strength Cu–Ni–Si alloyIntermetallics, 2013
- Effect of aluminum on microstructure and property of Cu–Ni–Si alloysMaterials Science and Engineering: A, 2013
- Tensile and electrical properties of direct aged Cu-Ni-Si-x%Ti alloysMetals and Materials International, 2013
- Microstructure and Properties of a High-Strength Cu-Ni-Si-Co-Zr AlloyJournal of Materials Engineering and Performance, 2013
- Effects of Ti addition and heat treatments on mechanical and electrical properties of Cu-Ni-Si alloysMetals and Materials International, 2013
- Dynamic embrittlement during fatigue of a Cu–Ni–Si alloyMaterials Science and Engineering: A, 2011
- Microstructure and properties of high-conductivity, super-high-strength Cu–8.0Ni–1.8Si–0.6Sn–0.15Mg alloyJournal of Materials Research, 2009