Turbocharger Synchronous Vibration Control on High Speed Balancer: Test and Prediction
- 18 February 2014
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 136 (7) , 071603
Abstract
Current trends for advanced automotive engines focusing on downsizing, better fuel efficiency, and lower emissions have led to several changes in turbocharger bearing systems design, and technology. Automotive turbochargers are running faster under high engine vibration level. Vibration control is becoming a real critical issue and turbocharger manufacturers are focusing more and more on new and improved balancing technology. This paper deals with turbocharger synchronous vibration control on high speed balancers. In a first step the synchronous rotordynamics behavior is identified. The developed fluid bearing code predicts bearing rotational speed (in case of fully floating design), operating inner and outer bearing film clearances and bearing force coefficients. A rotordynamics code uses this input to predict the synchronous lateral dynamic response of the rotor-bearing system by converging with bearing eccentricity ratio. The rotor-bearing system model is validated by shaft motion test data on high speed balancer (HSB). It shows that only one of the peaks seen on the synchronous G level plot collected in a high speed balancer can be explained by rotordynamics physics. A step-by-step structural dynamics model and analysis validated by experimental frequency response functions provides robust explanations for the other G level peaks. The synchronous vibration response of the system “turbocharger-HSB fixture” is predicted by integrating the predicted rotordynamics rotational bearing loads on the structural dynamics model. Numerous test data show very good correlation with the prediction, which validates the developed analytical model. The “rotordynamics—structural dynamics model” allows deep understanding of turbocharger synchronous vibration control, as well as optimization of the high speed balancer tooling.Keywords
This publication has 8 references indexed in Scilit:
- Nonlinear Dynamic Behavior of Turbocharger Rotor-Bearing Systems With Hydrodynamic Oil Film and Squeeze Film Damper in Series: Prediction and ExperimentJournal of Computational and Nonlinear Dynamics, 2010
- Turbocharger Nonlinear Response With Engine-Induced Excitations: Predictions and Test DataJournal of Engineering for Gas Turbines and Power, 2009
- Nonlinear Dynamic Behavior of Rotor-Bearing Systems Involving Two Hydrodynamic Oil Films in Series: Prediction and Test Application to High-Speed Turbochargers2006
- Identification of Frequency-Dependent Parameters in a Flexible Rotor SystemJournal of Engineering for Gas Turbines and Power, 2005
- An investigation on the influence of the supporting structure on the dynamics of the rotor systemMechanical Systems and Signal Processing, 2005
- Rigid Body and Nonlinear Mount Identification : Application to Onboard Equipment With Hysteretic SuspensionJournal of Vibration and Control, 1999
- Estimating turbogenerator foundation parametersProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 1998
- A Finite Rotating Shaft Element Using Timoshenko Beam TheoryJournal of Mechanical Design, 1980