Numerical Study on Heat Transfer Efficiency and Inter-Layer Stress of Microchannel Heat Sinks with Different Geometries
Open Access
Abstract
As electronics become more powerful and compact, laminated microchannel heat sinks (MCHSs) are essential for handling high heat flux. This study aims to optimize the MCHS design for improved heat dissipation and structural strength. An orthogonal experiment was established with the average surface temperature of the heat source as the evaluation metric, and the optimal structure was determined through simulation. Finally, cooling uniformity, fluidity, and performance evaluation criterion (PEC) analyses were carried out on the optimal structure. It was determined that the optimal combination was the triangular cavity microchannel (MCTC), with a microchannel width of 0.5 mm, a microchannel distribution density of 60%, and the presence of surface undulation on the microchannels. The result shows that the optimal structure’s peak inter-layer stress is just 34.8% of its longitudinal tensile strength. Compared to the traditional parallel straight microchannel (MCPS), this structure boasts an 8.6 K decrease in the average surface temperature and a temperature variation along specific paths that is only 9.9% of that in traditional designs. Moreover, the optimal design cuts the velocity loss at the microchannel entrance from 75% to 59%. Thus, this research successfully develops an effective optimization strategy for MCHSs.Keywords
Funding Information
- GF project of China (80923020104, 252062302)
- School-Enterprise Collaborative Innovation Fund for graduate students of the Xi’an University of Technology (80923020104, 252062302)
This publication has 39 references indexed in Scilit:
- A comprehensive review electronic cooling: A nanomaterial perspectiveInternational Journal of Thermofluids, 2023
- Thermal Performance of Mini Cooling Channels for High-Power Servo Motor with Non-Uniform Heat DissipationJournal of Thermal Science, 2023
- Topology optimization for a water-cooled heat sink in micro-electronics based on Pareto frontierApplied Thermal Engineering, 2022
- A fully developed flow thermofluid model for topology optimization of 3D-printed air-cooled heat exchangersApplied Thermal Engineering, 2017
- Design study of micro heat sink configurations with offset zigzag channel for specific chips geometricsEnergy Conversion and Management, 2016
- A comparative analysis of innovative microchannel heat sinks for electronic coolingInternational Communications in Heat and Mass Transfer, 2016
- Temperature distribution and thermal stresses in various conditions of moving heating source during line heating processJournal of Thermal Science, 2012
- Study on the convective heat transfer and pressure drop in the micro-channel heat sinkInternational Communications in Heat and Mass Transfer, 2009
- Improving wooden parts' quality by adopting DMAIC procedureQuality and Reliability Engineering International, 2008
- Effect of axial conduction on the heat transfer in micro-channelsInternational Journal of Heat and Mass Transfer, 2004