Tensile, flow, and thermal properties of CaCO3‐filled LDPE/LLDPE composites
Author:
- 26 February 2007
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 104 (3) , 1692-1696
Abstract
Calcium carbonate (CaCO3)‐filled low‐density polyethylene (LDPE)/linear low‐density polyethylene (LLDPE) composites were fabricated by means of a twin‐screw extruder, and the tensile mechanical properties of the tubing with thickness of 0.5 mm made from these composites were measured at room temperature to identify the effect of the filler concentration on the properties of these composites. The results showed that the tensile elastic modulus increased roughly linearly with increasing weight fraction (ϕf) of the fillers. The tensile fracture strength (σb) along longitudinal direction was obviously higher than that along transverse direction under the same test conditions, especially at higher filler concentration. The values of σb of the specimens along both the two directions achieved minimum at ϕf = 20%. Furthermore, the melt flow rate (MFR) and heat enthalpy (ΔH) of the composite materials were measured. It was found that both the MFR and the ΔH decreased with the addition of ϕf. The ΔH for the composite with LDPE/LLDPE ratio of 70/30 was higher than that of the composite with LDPE/LLDPE ratio of 50/50 at the same filler concentration, but contrary to the MFR. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 1692–1696, 2007Keywords
This publication has 12 references indexed in Scilit:
- Properties Predictor for HDPE/LDPE/LLDPE Blends for Shrink Film ApplicationsJournal of Plastic Film & Sheeting, 2006
- Elongational rheology of LLDPE / LDPE blendsJournal of Applied Polymer Science, 2003
- Morphology and mechanical properties of blown films of a low‐density polyethylene/linear low‐density polyethylene blendJournal of Polymer Science Part B: Polymer Physics, 2002
- The elastic behaviour during capillary extrusion of LDPE/LLDPE blend meltsPolymer Testing, 2002
- Studies on melt flow properties of low density and linear low density polyethylene blends in capillary extrusionPolymer Testing, 1997
- Shear and elongational behavior of linear low‐density and low‐density polyethylene blends from capillary rheometryPolymer Engineering & Science, 1994
- Visualization of the flow of linear low density polyethylene/low density polyethylene blends through sudden contractionsJournal of Non-Newtonian Fluid Mechanics, 1992
- Linear low density polyethylenes and their blends: Part 4 shear flow of LLDPE blends with LLDPE and LDPEPolymer Engineering & Science, 1987
- Flow properties of low density/linear low density polyethylenesPolymer Engineering & Science, 1986
- Stress‐strain behavior of styrene‐acrylonitrile/glass bead composites in the glassy regionPolymer Engineering & Science, 1971