Elastic buckling of rectangular fiber-metal laminated plates under uniaxial compression
- 8 April 2019
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 33 (12) , 1629-1651
Abstract
In this article, the elastic buckling response of rectangular simply supported and clamped fiber-metal laminates (FMLs) subjected to uniaxial compressive loading is investigated using the finite element method and eigenvalue buckling analysis. Using validated finite element method (FEM) models, the buckling coefficient-aspect ratio diagrams and the mode shapes of nine GLARE grades are obtained and studied along with the diagrams and the mode shapes of three unidirectional glass-epoxy composites and monolithic 2024-T3 aluminum. It is found that the critical average buckling stress and the buckling load of the materials increases for increasing metal volume fraction, when the plate aspect ratio is greater than 1.5. The rule of mixtures is evaluated and found to be a simple method to estimate approximately the average critical buckling stress of the GLARE plates. An approximate formula is derived for the estimation of the critical buckling coefficient of the GLARE plates using the buckling coefficients of their constituents. The applicability of the results to thermoplastic-based FMLs is discussed.Keywords
This publication has 25 references indexed in Scilit:
- An integrated study on the low-velocity impact response of the GLARE fibre-metal laminateComposite Structures, 2013
- Stacking Sequence and Geometrical Effects on Low-Velocity Impact Behaviors of GLARE 5 (3/2) Fiber–Metal LaminatesJournal of Thermoplastic Composite Materials, 2011
- Investigation of Scaling Effects in Fiber—Metal LaminatesJournal of Composite Materials, 2008
- Characterization of long fiber thermoplastic/metal laminatesJournal of Materials Science, 2008
- The Impact Properties of High-temperature Fiber-Metal LaminatesJournal of Composite Materials, 2007
- Ballistic impact of GLARE™ fiber–metal laminatesComposite Structures, 2003
- Effect of Cross Section Material Distribution on Impact Response of Hybrid CompositesJournal of Thermoplastic Composite Materials, 2002
- Effect of Pre-strain on Nonlinear Deformation of Reinforced Polymer/Aluminum LaminatesJournal of Thermoplastic Composite Materials, 1994
- Nonlinear Elastic Behavior of Unidirectional Composite LaminaeJournal of Composite Materials, 1973
- Analysis of Anisotropic PlatesJournal of Composite Materials, 1969