Collection of Liquid Phase Particles by Microfabricated Electrostatic Precipitator
- 3 July 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 22 (5) , 1010-1019
Abstract
A microfabricated electrostatic precipitator successfully demonstrated its airborne liquid phase particles precipitation functionality. The particles used in the experiments were polydispersed liquid phase oleic acid particles with sizes ranging from 30 nm to 300 nm. Two configurations with electrode gaps of 1.8 mm and 2.0 mm were tested at 2.2 kV and 2.6kV, respectively. During the test, the microfabricated electrostatic precipitator was inserted into a flow chamber with an aerosol stream containing oleic acid particles. Particle precipitation is demonstrated via both visual observation and the measurement of the corona current during aerosol exposure. The corona current for the 2.0 mm electrode gap configuration was decreased by approximately 50% and the circuit resistivity is increased by the corresponding magnitude as the oleic acid particles precipitated during a 60s exposure. The recovery of corona current is observed when the aerosol source is turned off. Wicking of precipitated oleic acid away from the collection grid to its anchoring feature is observed. The analytical and experimental corona current versus time elapsed during the aerosol exposure are calculated and compared. The discrepancy between the analytical and experimental corona currents is consistent with the observed wicking effect and variation in percent coverage on the collector grid by precipitating particles.Keywords
This publication has 19 references indexed in Scilit:
- A novel polymer-arrayed electrostatic precipitator with electrical resistance material for the removal of fine particlesJournal of Aerosol Science, 2013
- The influence of nozzle throat length on the resolution of a low pressure impactor—An experimental and numerical studyJournal of Aerosol Science, 2012
- Simulation of low pressure impactor collection efficiency curvesJournal of Aerosol Science, 2011
- Calibration of the Modified Electrical Low-Pressure Impactor (ELPI) for Use with Pressurized Pharmaceutical AerosolsJournal of Aerosol Medicine and Pulmonary Drug Delivery, 2009
- Design, Fabrication, and Testing of a Microfabricated Corona IonizerJournal of Microelectromechanical Systems, 2008
- Modern electrostatic devices and methods for exhaust gas cleaning: A brief reviewJournal of Electrostatics, 2007
- High Q Achieved in Microwave Inductors Fabricated by Parallel Self-Assembly2001
- History of Electrical Aerosol MeasurementsAerosol Science and Technology, 1998
- Enhancement of electrostatic precipitator ultrafine particle collection efficiency by prechargersJournal of Aerosol Science, 1997
- A derivation of Warburg’s law for point to plane coronasJournal of Applied Physics, 1981