Experimental Investigation into Stability, Heat Transfer, and Flow Characteristics of TiO2-SiO2 Hybrid Nanofluids Under Multiple Influencing Factors
Open Access
- 15 March 2026
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 16 (6) , 359
Abstract
Extensive research and empirical evidence demonstrate that nanofluids enhance heat transfer efficiency in microchannels, but this improvement is often accompanied by increased pressure drop and particle clogging. This study aims to determine the optimal parameters for preparing stable nanofluids and to discuss the effects of different parameters on thermal and hydraulic performance. By analyzing the impact of varying ultrasonication time, particle concentration, particle size, surfactant type, and mixing ratios on stability, the most stable nanofluid was selected for evaluation of flow heat transfer and cost-effectiveness. Results indicate that a 1:1 mixed nanofluid of TiO2 (20 nm)-SiO2 (50 nm) exhibits optimal stability under conditions of 90 min ultrasonication, 0.20 vol% total particle concentration, and 0.15 wt% xanthan gum. At a Reynolds number of 550, this mixed nanofluid exhibits superior thermal performance. Compared with deionized water, its convective heat transfer coefficient and Nusselt number increase by 40.25% and 37.94%, respectively, while the pressure drop rises by only 17.18%. The performance evaluation criterion reaches 1.43, accompanied by a high cost–performance factor. These findings demonstrate that mixing large and small particles of TiO2 and SiO2 not only significantly enhances thermal performance but also positively impacts stability and hydraulic properties. A 90 min ultrasonic treatment time markedly improves stability and optimizes dynamic light scattering results.Keywords
Funding Information
- Fushun Revitalization Talents Program (FSYC202407004)
- Basic Scientific Research Project of the Educational Department of Liaoning Province (JYTMS20231455)
This publication has 105 references indexed in Scilit:
- Investigation of thermo-optical properties and photothermal conversion performance of MWCNT, Fe3O4, and ATO nanofluid for volumetric absorption solar collectorApplied Thermal Engineering, 2024
- Hydrothermal performance through multiple shapes of microchannels (MCHS) using nanofluids: an exhaustive reviewJournal of Thermal Analysis and Calorimetry, 2023
- Enhancing solar thermal energy harvesting efficiency and temperature uniformity of Fe3O4 nanofluid in receiver of direct solar thermal collector using dynamic magnetic fieldApplied Thermal Engineering, 2023
- Multiphysics CFD modeling to assess performance of a perforated multi-plate indirect solar dryer with a V-corrugated absorber surfaceApplied Thermal Engineering, 2023
- A review of the use of nanofluids as heat-transfer fluids in parabolic-trough collectorsApplied Thermal Engineering, 2022
- Thermal performance improvement in water nanofluid/GNP–SDBS in novel design of double-layer microchannel heat sink with sinusoidal cavities and rectangular ribsJournal of Thermal Analysis and Calorimetry, 2018
- An experimental and theoretical investigation on heat transfer capability of Mg (OH)2/MWCNT-engine oil hybrid nano-lubricant adopted as a coolant and lubricant fluidApplied Thermal Engineering, 2018
- Experimental study on thermal conductivity of ethylene glycol containing hybrid nano-additives and development of a new correlationApplied Thermal Engineering, 2017
- CFD study of constructal microchannel networks for liquid-cooling of electronic devicesApplied Thermal Engineering, 2016
- Describing the uncertainties in experimental resultsExperimental Thermal and Fluid Science, 1988