Evaluation of Bonding Behavior between Engineered Geopolymer Composites with Hybrid PE/PVA Fibers and Concrete Substrate
Open Access
Abstract
Engineered geopolymer composites (EGCs) exhibit excellent tensile ductility and crack control ability, making them promising for concrete structure repair. However, their widespread use is limited by high costs of reinforcement fiber and a lack of an EGC–concrete interface bonding mechanism. This study investigated a hybrid PE/PVA fiber-reinforced EGC using domestically produced unoiled PVA fibers to replace commonly used PE fibers. The bond performance of the EGC–concrete interface was evaluated through direct tensile and slant shear tests, focusing on the effects of PE fiber content (1%, 2%, and 3%), fiber hybrid ratios (2.0:0.0, 1.5:0.5, 1.0:1.0, 0.5:1.5, and 0.0:2.0), concrete substrate strength (C30, C50, and C70), and the ratio of fly ash (FA) to ground granulated blast furnace slag (GGBS) (6:4, 7:3, and 8:2) on interface bond strength. Results showed that the EGCs’ compressive strength ranged from 77.1 to 108.9 MPa, with increased GGBS content significantly enhancing the compressive strength and elastic modulus. Most of the specimens exhibited strain-hardening behavior after initial cracking. Interface bonding tests revealed that a PE/PVA ratio of 1.0 increased tensile bond strength by 8.5% compared with using 2.0% PE fiber alone. Increasing the PE fiber content, PVA/PE ratio, GGBS content, and concrete substrate strength all improved the shear bond strength. This improvement was attributed to the flexible fibers’ ability to restrict thermo–hydro damage and deflect and blunt microcracks, enhancing the interface’s failure resistance. Cost analysis showed that replacing 50% of the PE fiber in EGC with unoiled PVA fiber reduced costs by 44.2% compared with PE fiber alone, offering the best cost–performance ratio. In summary, hybrid PE/PVA fiber EGC has promising prospects for improving economic efficiency while maintaining tensile ductility and crack-control ability. Future optimization of fiber ratios and interface design could further enhance its potential for concrete repair applications.Keywords
Funding Information
- Guangzhou Power Supply Bureau (0301002024030301XG00030)
This publication has 55 references indexed in Scilit:
- Strain-hardening alkali-activated fly ash/slag composites with ultra-high compressive strength and ultra-high tensile ductilityCement and Concrete Research, 2022
- Engineered geopolymer composites: A state-of-the-art reviewCement and Concrete Composites, 2022
- Bar size effect on long-term durability of sand-coated basalt-FRP composite barsComposites Part B: Engineering, 2020
- Shear strengthening of RC beams with FRP grid-reinforced ECC matrixComposite Structures, 2020
- Experimental study on seismic behaviours of hybrid FRP–steel-reinforced ECC–concrete composite columnsComposites Part B: Engineering, 2019
- Durability performance and long-term prediction models of sand-coated basalt FRP barsComposites Part B: Engineering, 2019
- Micromechanical properties of alkali-activated slag cement bindersCement and Concrete Composites, 2018
- Basic mechanical properties of ultra-high ductility cementitious composites: From 40 MPa to 120 MPaComposite Structures, 2018
- Effect of accelerated freeze–thaw cycling on mechanical properties of hybrid PVA and PE fiber-reinforced strain-hardening cement-based composites (SHCCs)Composites Part B: Engineering, 2013
- Nanoindentation characteristics of alkali-activated aluminosilicate materialsCement and Concrete Composites, 2011