Microstructural Evolution and Property Evaluation of In Situ Al–MgAl2O4 Nanocomposite Prepared by γ‐Al2O3 and Ultrasonication‐Assisted Impeller Mixing
- 1 June 2024
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 26 (13)
Abstract
In situ Al–MgAl2O4 nanocomposite billet is prepared by the reaction of γ‐Al2O3 with molten Al and ultrasonication‐assisted impeller mixing. The microstructure of the composite shows homogeneously distributed MgAl2O4 crystals alongside their clusters in the Al matrix. Microstructural analysis reveals MgAl2O4 crystals distributed from 20 nm to 4 μm in size. The hardness is found to vary within the composite from 50 Hv for the matrix to 140 Hv for the particle cluster regions. The grain size is reduced from 1000 μm in reference metal (commercially pure Al [CPAl]) to 100 μm in the composite. The compression strength of the composite is increased substantially and higher strain‐hardening effect in comparison with Al is noticed in the compression test. The signatures of extensive plastic deformation such as dislocation pileups, deformed grains, grain boundary pinning, and so on are observed in the composite via transmission electron microscopy. Damping properties of as‐cast composite are higher than those of CPAl in the temperature range from room temperature (RT) to 350 °C. After rolling the composite, the damping capacity (Tanδ) of the composite is found to increase marginally after 150 °C. Higher damping is found to reoccur after the annealing treatment of the composite.Keywords
This publication has 37 references indexed in Scilit:
- Powder Metallurgy versus Casting: Damping Behavior of Pure AluminumJournal of Materials Engineering and Performance, 2022
- Prospects of In-Situ α-Al2O3 as an Inoculant in Aluminum: A Feasibility StudyJournal of Materials Engineering and Performance, 2017
- Potential of an Al-Ti-MgAl2O4 Master Alloy and Ultrasonic Cavitation in the Grain Refinement of a Cast Aluminum AlloyMetallurgical and Materials Transactions B, 2016
- On the Mechanism of Ultrasound-Driven Deagglomeration of Nanoparticle Agglomerates in Aluminum MeltJOM, 2016
- Processing of Ultrafine-Size Particulate Metal Matrix Composites by Advanced Shear TechnologyMetallurgical and Materials Transactions A, 2009
- Tensile Properties and Microstructure of SiC Nanoparticle–Reinforced Mg-4Zn Alloy Fabricated by Ultrasonic Cavitation–Based Solidification ProcessingMetallurgical and Materials Transactions A, 2008
- Thermodynamics and Kinetics of the Formation of Al2O3/ MgAl2O4/MgO in Al-Silica Metal Matrix CompositeMetallurgical and Materials Transactions A, 2008
- Evolution of MgAl2O4 crystals in Al-Mg-SiO2 compositesApplied Physics A, 2007
- Novel Nanoparticle‐Reinforced Metal Matrix Composites with Enhanced Mechanical PropertiesAdvanced Engineering Materials, 2007
- Crystallography of SiC/MgAlO/Al interfaces in a pre-oxidized SiC reinforced SiC/Al compositeActa Materialia, 2006