Improving the Efficiency and Stability of Perovskite Solar Cells by Refining the Perovskite-Electron Transport Layer Interface and Shielding the Absorber from UV Effects
Open Access
- 27 May 2024
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (22) , 28493-28504
Abstract
This study aims to enhance the performance of perovskite solar cells (PSCs) by optimizing the interface between the perovskite and electron transport layers (ETLs). Additionally, we plan to protect the absorber layer from ultraviolet (UV) degradation using a ternary oxide system comprising SnO2, strontium stannate (SrSnO3), and strontium oxide (SrO). In this structure, the SnO2 layer functions as an electron transport layer, SrSnO3 acts as a layer for UV filtration, and SrO is employed to passivate the interface. SrSnO3 is characterized by its chemical stability, electrical conductivity, extensive wide band gap energy, and efficient absorption of UV radiation, all of which significantly enhance the photostability of PSCs against UV radiation. Furthermore, incorporating SrSnO3 into the ETL improves its electronic properties, potentially raising the energy level and improving alignment, thereby enhancing the electron transfer from the perovskite layer to the external circuit. Integrating SrO at the interface between the ETL and perovskite layer reduces interface defects, thereby reducing charge recombination and improving electron transfer. This improvement results in higher solar cell efficiency, reduced hysteresis, and extended device longevity. The benefits of this method are evident in the observed improvements: a noticeable increase in open-circuit voltage (Voc) from 1.12 to 1.16 V, an enhancement in the fill factor from 79.4 to 82.66%, a rise in the short-circuit current density (Jsc) from 24.5 to 24.9 mA/cm2 and notably, a marked improvement in the power conversion efficiency (PCE) of PSCs, from 21.79 to 24.06%. Notably, the treated PSCs showed only a slight decline in PCE, reducing from 24.15 to 22.50% over nearly 2000 h. In contrast, untreated SnO2 perovskite devices experienced a greater decline, with efficiency decreasing from 21.79 to 17.83% in just 580 h.Keywords
Funding Information
- National Key Research and Development Program of China (2020YFB0408002)
This publication has 60 references indexed in Scilit:
- Hydrothermal Deposition of UV‐Absorbing Passivation Layers for Efficient and Stable Perovskite Solar CellsAdvanced Energy and Sustainability Research, 2023
- Electron‐Selective Strontium Oxide Contact for Crystalline Silicon Solar Cells with High Fill FactorSolar RRL, 2023
- Advances in Encapsulations for Perovskite Solar Cells: From Materials to ApplicationsSolar RRL, 2023
- UV‐induced degradation of high‐efficiency silicon PV modules with different cell architecturesProgress in Photovoltaics: Research and Applications, 2022
- Ultraviolet Photocatalytic Degradation of Perovskite Solar Cells: Progress, Challenges, and StrategiesAdvanced Energy and Sustainability Research, 2022
- Selection of the ultimate perovskite solar cell materials and fabrication processes towards its industrialization: A reviewEnergy Science & Engineering, 2022
- A Perspective on the Commercial Viability of Perovskite Solar CellsSolar RRL, 2021
- Overcoming Ni3+‐Induced Non‐Radiative Recombination at Perovskite‐Nickel Oxide Interfaces to Boost Voltages in Perovskite Solar CellsAdvanced Materials Interfaces, 2021
- Understanding the Interplay of Binary Organic Spacer in Ruddlesden–Popper Perovskites toward Efficient and Stable Solar CellsAdvanced Functional Materials, 2020
- Defects and dopant properties of SrSnO3 compound: A computational studyComputational Condensed Matter, 2019