Nondestructive analysis of single crystals of selenide spinels by X-ray spectrometry techniques
Open Access
- 6 October 2010
- journal article
- conference paper
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 399 (9) , 3285-3292
Abstract
The paper presents possibilities and difficulties in nondestructive analysis of small multielement single crystals performed by means of X-ray spectrometry techniques: micro-X-ray fluorescence spectrometry (μ-XRF), energy-dispersive electron probe microanalysis (ED-EPMA), and X-ray photoelectron spectroscopy (XPS). The capability of the X-ray spectroscopy techniques in elemental analysis is demonstrated with the single crystals of selenide spinels of the general formula M x N y Cr z Se4 (M+2 and N+3 are, for example, Zn+2, V+3, Ga+3, Cd+2, In+3, and Sb+3). The results of the nondestructive analyses (μ-XRF, ED-EPMA, and XPS) are compared with those obtained by inductively coupled plasma optical emission spectrometry (ICP-OES) and wavelength-dispersive X-ray spectrometry (WDXRF) following sample digestion. The present study shows satisfactory agreement between the results of μ-XRF analysis performed using the standardless fundamental parameter method and the results obtained with the WDXRF and ICP-OES analyses. If the measured single crystal is precisely positioned, the difference between μ-XRF and wet analysis (WDXRF and ICP-OES) does not exceed 5% rel. The reliable results of ED-EPMA can be obtained only if the measured area is sufficiently large, i.e., of 200 × 300 μm. Even if this condition is fulfilled, the relative difference between the ED-EPMA and the wet analysis may reach 10% rel. In case of the XPS analysis, the accuracy of results depends on the proper preparation of the sample surface. It should be free of contamination that can be obtained by scraping in situ in ultrahigh vacuum. The ion etching, commonly used for cleaning the surface, leads to preferential sputtering; therefore, the reliable results cannot be obtained. The paper presents possibilities and difficulties in nondestructive analysis of small multielement single crystals performed by means of X-ray spectrometry techniques: micro-XRF, ED-EPMA and XPS.Keywords
This publication has 19 references indexed in Scilit:
- Thickness measurement of semiconductor thin films by energy dispersive X-ray fluorescence benchtop instrumentation: Application to GaN epilayers grown by molecular beam epitaxySpectrochimica Acta Part B: Atomic Spectroscopy, 2010
- Correlation between the negative magnetoresistance effect and magnon excitations in single-crystalline CuCr1.6V0.4Se4Philosophical Magazine, 2010
- Study of epitaxial selective area growth In1−xGaxAs films by synchrotron μ-XRF mappingJournal of Analytical Atomic Spectrometry, 2010
- Influence of temperature on the critical fields in ZnCr2−xAlxSe4 antiferromagnetsJournal of Alloys and Compounds, 2009
- Standardless energy-dispersive X-ray fluorescence analysis using primary radiation monochromatized with LiF(200) crystalSpectrochimica Acta Part B: Atomic Spectroscopy, 2008
- Temperature dependent lattice instability in single crystals of ferromagnetic CdCr2Se4diluted with In and SbJournal of Physics: Condensed Matter, 2008
- Polar phonons and spin-phonon coupling in and studied with far-infrared spectroscopyPhysical Review B, 2007
- Addition of M‐ and L‐series lines to NIST algorithm for calculation of x‐ray tube output spectral distributionsX-Ray Spectrometry, 1991
- An analytical algorithm for calculation of spectral distributions of x‐ray tubes for quantitative x‐ray fluorescence analysisX-Ray Spectrometry, 1985
- The theoretical derivation of fluorescent X-ray intensities from mixturesSpectrochimica Acta, 1955