Jan Heimann
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jan Heimann has a total of 90 co-authors. Here are the top co-authors by number of shared publications:
E. Talik
Department of Physics, Silesian University, 40‐007 Katowice, ul. Uniwersytecka 4, Poland
15 shared publications- Jacek Szade
A. Chełkowski Institute of Physics, University of Silesia, 41-500 Chorzów, Poland
14 shared publications A. Chełkowski
11 shared publications- Ewa Malicka
Institute of Chemistry, University of Silesia, Szkolna 9, 40-006 Katowice, Poland
9 shared publications T. Mydlarz
7 shared publicationsA. Winiarski
Institute of Physics, Silesian University, Uniwersytecka 4, 40-007 Katowice, Poland
5 shared publications
Latest Publications
- Top Cited Papers
- 7 February 2013
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 42 (16) , 5682-5689
Adsorption of divalent metal ions from aqueous solutions using graphene oxide
The adsorptive properties of graphene oxide (GO) towards divalent metal ions (copper, zinc, cadmium and lead) were investigated. GO prepared through the oxidation of graphite using potassium dichromate was characterized by scanning electron microscopy (SEM), powder X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and infrared spectroscopy (FT-IR). The results of batch experiments and measurements by flame atomic absorption spectrometry (F-AAS) indicate that maximum adsorption can be achieved in broad pH ranges: 3–7 for Cu(II), 5–8 for Zn(II), 4–8 for Cd(II), 3–7 for Pb(II). The maximum adsorption capacities of Cu(II), Zn(II), Cd(II) and Pb(II) on GO at pH = 5 are 294, 345, 530, 1119 mg g−1, respectively. The competitive adsorption experiments showed the affinity in the order of Pb(II) > Cu(II) ≫ Cd(II) > Zn(II). Adsorption isotherms and kinetic studies suggest that sorption of metal ions on GO nanosheets is monolayer coverage and adsorption is controlled by chemical adsorption involving the strong surface complexation of metal ions with the oxygen-containing groups on the surface of GO. Chemisorption was confirmed by XPS (binding energy and shape of O1s and C1s peaks) of GO with adsorbed metal ions. The adsorption experiments show that the dispersibility of GO in water changes remarkably after complexation of metal ions. After adsorption, the tendency to agglomerate and precipitate is observed. Excellent dispersibility of GO and strong tendency of GO–Me(II) to precipitate open the path to removal of heavy metals from water solution. Potential application of GO in analytical chemistry as a solid sorbent for preconcentration of trace elements and in heavy metal ion pollution cleanup results from its maximum adsorption capacities that are much higher than those of any of the currently reported sorbents.
- 7 February 2013
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 42 (16) , 5682-5689
Top Cited PapersAdsorption of divalent metal ions from aqueous solutions using graphene oxide
The adsorptive properties of graphene oxide (GO) towards divalent metal ions (copper, zinc, cadmium and lead) were investigated. GO prepared through the oxidation of graphite using potassium dichromate was characterized by scanning electron microscopy (SEM), powder X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and infrared spectroscopy (FT-IR). The results of batch experiments and measurements by flame atomic absorption spectrometry (F-AAS) indicate that maximum adsorption can be achieved in broad pH ranges: 3–7 for Cu(II), 5–8 for Zn(II), 4–8 for Cd(II), 3–7 for Pb(II). The maximum adsorption capacities of Cu(II), Zn(II), Cd(II) and Pb(II) on GO at pH = 5 are 294, 345, 530, 1119 mg g−1, respectively. The competitive adsorption experiments showed the affinity in the order of Pb(II) > Cu(II) ≫ Cd(II) > Zn(II). Adsorption isotherms and kinetic studies suggest that sorption of metal ions on GO nanosheets is monolayer coverage and adsorption is controlled by chemical adsorption involving the strong surface complexation of metal ions with the oxygen-containing groups on the surface of GO. Chemisorption was confirmed by XPS (binding energy and shape of O1s and C1s peaks) of GO with adsorbed metal ions. The adsorption experiments show that the dispersibility of GO in water changes remarkably after complexation of metal ions. After adsorption, the tendency to agglomerate and precipitate is observed. Excellent dispersibility of GO and strong tendency of GO–Me(II) to precipitate open the path to removal of heavy metals from water solution. Potential application of GO in analytical chemistry as a solid sorbent for preconcentration of trace elements and in heavy metal ion pollution cleanup results from its maximum adsorption capacities that are much higher than those of any of the currently reported sorbents.
- 1 August 2012
- Published by Elsevier in Materials Research Bulletin
- Vol. 47 (8) , 1881-1886
Influence of manganese on magnetic and electronic properties of ZnCr2Se4
- 1 August 2012
- Published by Elsevier in Materials Research Bulletin
- Vol. 47 (8) , 1881-1886
Influence of manganese on magnetic and electronic properties of ZnCr2Se4
- 1 February 2012
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 513, 353-358
Structural and magnetic properties of CuCr2Se4 single crystals diluted with Sb(III)
- 1 February 2012
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 513, 353-358
Structural and magnetic properties of CuCr2Se4 single crystals diluted with Sb(III)
- 1 December 2011
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 131 (1-2) , 142-150
Specific heat and magnetic susceptibility of single-crystalline ZnCr2Se4 spinels doped with Ga, In and Ce
- 1 December 2011
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 131 (1-2) , 142-150
Specific heat and magnetic susceptibility of single-crystalline ZnCr2Se4 spinels doped with Ga, In and Ce
- 1 August 2011
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 72 (8) , 974-979
Specific heat and magnetic susceptibility of single-crystalline ZnCr2−Al Se4 (x=0.15, 0.23)
- 1 August 2011
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 72 (8) , 974-979
Specific heat and magnetic susceptibility of single-crystalline ZnCr2−Al Se4 (x=0.15, 0.23)
- Open Access
- 1 May 2011
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 119 (5) , 705-707
Magnetic Coupling in CuCr2X4(X = S, Se) Spinel Compounds Obtained via Substitution of the Chromium Ions by Nonmagnetic Sb or Al Ions
- 1 May 2011
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 119 (5) , 705-707
Open AccessMagnetic Coupling in CuCr2X4(X = S, Se) Spinel Compounds Obtained via Substitution of the Chromium Ions by Nonmagnetic Sb or Al Ions
- Open Access
- 6 October 2010
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 399 (9) , 3285-3292
Nondestructive analysis of single crystals of selenide spinels by X-ray spectrometry techniques
The paper presents possibilities and difficulties in nondestructive analysis of small multielement single crystals performed by means of X-ray spectrometry techniques: micro-X-ray fluorescence spectrometry (μ-XRF), energy-dispersive electron probe microanalysis (ED-EPMA), and X-ray photoelectron spectroscopy (XPS). The capability of the X-ray spectroscopy techniques in elemental analysis is demonstrated with the single crystals of selenide spinels of the general formula M x N y Cr z Se4 (M+2 and N+3 are, for example, Zn+2, V+3, Ga+3, Cd+2, In+3, and Sb+3). The results of the nondestructive analyses (μ-XRF, ED-EPMA, and XPS) are compared with those obtained by inductively coupled plasma optical emission spectrometry (ICP-OES) and wavelength-dispersive X-ray spectrometry (WDXRF) following sample digestion. The present study shows satisfactory agreement between the results of μ-XRF analysis performed using the standardless fundamental parameter method and the results obtained with the WDXRF and ICP-OES analyses. If the measured single crystal is precisely positioned, the difference between μ-XRF and wet analysis (WDXRF and ICP-OES) does not exceed 5% rel. The reliable results of ED-EPMA can be obtained only if the measured area is sufficiently large, i.e., of 200 × 300 μm. Even if this condition is fulfilled, the relative difference between the ED-EPMA and the wet analysis may reach 10% rel. In case of the XPS analysis, the accuracy of results depends on the proper preparation of the sample surface. It should be free of contamination that can be obtained by scraping in situ in ultrahigh vacuum. The ion etching, commonly used for cleaning the surface, leads to preferential sputtering; therefore, the reliable results cannot be obtained. The paper presents possibilities and difficulties in nondestructive analysis of small multielement single crystals performed by means of X-ray spectrometry techniques: micro-XRF, ED-EPMA and XPS.
- 6 October 2010
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 399 (9) , 3285-3292
Open AccessNondestructive analysis of single crystals of selenide spinels by X-ray spectrometry techniques
The paper presents possibilities and difficulties in nondestructive analysis of small multielement single crystals performed by means of X-ray spectrometry techniques: micro-X-ray fluorescence spectrometry (μ-XRF), energy-dispersive electron probe microanalysis (ED-EPMA), and X-ray photoelectron spectroscopy (XPS). The capability of the X-ray spectroscopy techniques in elemental analysis is demonstrated with the single crystals of selenide spinels of the general formula M x N y Cr z Se4 (M+2 and N+3 are, for example, Zn+2, V+3, Ga+3, Cd+2, In+3, and Sb+3). The results of the nondestructive analyses (μ-XRF, ED-EPMA, and XPS) are compared with those obtained by inductively coupled plasma optical emission spectrometry (ICP-OES) and wavelength-dispersive X-ray spectrometry (WDXRF) following sample digestion. The present study shows satisfactory agreement between the results of μ-XRF analysis performed using the standardless fundamental parameter method and the results obtained with the WDXRF and ICP-OES analyses. If the measured single crystal is precisely positioned, the difference between μ-XRF and wet analysis (WDXRF and ICP-OES) does not exceed 5% rel. The reliable results of ED-EPMA can be obtained only if the measured area is sufficiently large, i.e., of 200 × 300 μm. Even if this condition is fulfilled, the relative difference between the ED-EPMA and the wet analysis may reach 10% rel. In case of the XPS analysis, the accuracy of results depends on the proper preparation of the sample surface. It should be free of contamination that can be obtained by scraping in situ in ultrahigh vacuum. The ion etching, commonly used for cleaning the surface, leads to preferential sputtering; therefore, the reliable results cannot be obtained. The paper presents possibilities and difficulties in nondestructive analysis of small multielement single crystals performed by means of X-ray spectrometry techniques: micro-XRF, ED-EPMA and XPS.
- 31 August 2008
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 181 (8) , 1970-1976
Structural and magnetic properties of Zn1−xSbxCr2−x/3Se4 (x=0.11, 0.16 and 0.20) single crystals
- 31 August 2008
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 181 (8) , 1970-1976
Structural and magnetic properties of Zn1−xSbxCr2−x/3Se4 (x=0.11, 0.16 and 0.20) single crystals
- 26 October 2006
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 423 (1-2) , 43-46
Magnetic state in RAgAl (R=Dy, Ho, Er)
- 26 October 2006
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 423 (1-2) , 43-46
Magnetic state in RAgAl (R=Dy, Ho, Er)
- 17 October 2005
- Published by Wiley in Chemical Vapor Deposition
- Vol. 11 (10) , 399-403
CVD of Thin Titanium Dioxide Films Using Hexanuclear Titanium Oxo Carboxylate Isopropoxides
- 17 October 2005
- Published by Wiley in Chemical Vapor Deposition
- Vol. 11 (10) , 399-403
CVD of Thin Titanium Dioxide Films Using Hexanuclear Titanium Oxo Carboxylate Isopropoxides