Effects of porcelain veneering methods on conformity of the marginal and internal fit of three-unit zirconia framework
Authors:
- 23 March 2021
- journal article
- research article
- Published by Springer Nature in Odontology
- Vol. 109 (3) , 719-728
Abstract
The purpose of this study is to investigate the effects of porcelain veneering methods on the marginal and internal fit of a three-unit zirconia framework. A zirconia master model, in which the lower-left second premolar and the second left molar were used as the abutment, was obtained using an intraoral scanner. Based on the data, three-unit zirconia frameworks for fabricating all-ceramic bridges were designed and milled (FW group). Two types of all-ceramic bridge were fabricated by veneering porcelain onto these frameworks using the press-over technique (P group) and the layering technique (L group). The replica technique was used to measure the gap size between the abutments and the bridges. Measurements were taken in the marginal opening area (MO), chamfer area (CH), axial area (AX), and occlusal area (OC). Statistical analysis was performed using the Mann–Whitney U-test. There was no significant difference in MO and CH between the P and L groups. However, in AX, the L group had a significantly larger gap size than that of the P group (p = 0.003). In addition, compared with the FW group, the P group showed a significantly larger gap size in MO (p < 0.000), CH (p = 0.008), and OC (p < 0.000). These results indicate that the gap size increased after porcelain veneering using the press-over and layering techniques. In addition, the all-ceramic bridges fabricated using the press-over and layering techniques had approximately equal gap sizes in MO.Keywords
This publication has 30 references indexed in Scilit:
- Fit of zirconia fixed partial denture: a systematic reviewJournal of Oral Rehabilitation, 2010
- Influence of the veneering process on the marginal fit of zirconia fixed dental prosthesesJournal of Oral Rehabilitation, 2010
- Influence of porcelain veneering on the marginal fit of Digident and Lava CAD/CAM zirconia ceramic crownsThe Journal of Advanced Prosthodontics, 2010
- High-strength CAD/CAM-fabricated veneering material sintered to zirconia copings — A new fabrication mode for all-ceramic restorationsDental Materials, 2009
- An In Vitro Evaluation of Fit of Zirconium‐Oxide‐Based Ceramic Four‐Unit Fixed Partial Dentures, Generated with Three Different CAD/CAM Systems, before and after Porcelain Firing Cycles and after Glaze CyclesJournal of Prosthodontics, 2008
- Prestresses in bilayered all‐ceramic restorationsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2008
- Influence of firing cycles on the margin distortion of 3 all-ceramic crown systemsThe Journal of Prosthetic Dentistry, 2005
- The effect of core:dentin thickness ratio on the bi-axial flexure strength and fracture mode and origin of bilayered dental ceramic compositesDental Materials, 2005
- Thermal expansion of dental alloys and porcelainsJournal of Biomedical Materials Research, 1980
- The estimation of cement film thickness by an in vivo techniqueBritish Dental Journal, 1971