Effect of pedestal current on the density window for ELM suppression using n = 4 RMP in EAST
Open Access
- 1 September 2026
- journal article
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 68 (9) , 095026
Abstract
Existence of operational window in both edge safety factor ( q 95 ) and line averaged plasma density ( ⟨ n e ⟩ ) for suppression of edge localized modes (ELMs) using n = 4 resonant magnetic perturbations (RMPs) in low input torque plasmas has been observed in EAST experiment, in which q 95 and plasma normalized beta ( β N ) close to that required in ITER high- Q operation. Here, n is toroidal mode number of the magnetic perturbation. In contrast to previous reports from other tokamaks, there is not only an upper density limit but also a lower one for accessing ELM suppression. Modeling results using the MARS-F code show that the RMP with linear plasma response has a peak at an intermediate density and decays as the density increases or decreases, which results in a minimal RMP field penetration threshold at the intermediate density. In this experiment, the observed lower density limit operationally manifests a sensitivity of the q -profile: different densities alter the edge current profile, which change the alignment of the eigenmode structure with the RMP coil configuration, causing a reduction of the resonant field in both low- and high-density cases, and hence making field penetration more difficult. The modeled window of the strongest resonant plasma response in terms of [ ⟨ n e ⟩ , q 95 ] agrees well with the observed ELM suppression in EAST. Peeling–ballooning modes (PBMs) stability analysis using the ELITE code shows that plasmas gradually approach the peeling instability boundary caused by an increase of edge bootstrap current as the plasma density decreases, which is consistent with the observation that ELMs come back again in lower density plasmas for fixed q 95 . These results indicate that linear modeling with full toroidal geometry can well predict the optimized RMP configuration for ELM suppression and reveal the important roles of pedestal plasma current, which needs to be carefully considered in the application of high n RMPs for ELM suppression in future ITER.Keywords
Funding Information
- The National MCF Energy R&D Program (No. 2024YFE03270800 and No. 2024YFE03010000)
- The Strategic Priority Research Program of Chinese Academy of Sciences (No. XDB0790100)
This publication has 56 references indexed in Scilit:
- Comparative investigation of ELM control based on toroidal modelling of plasma response to RMP fieldsPhysics of Plasmas, 2017
- Three-dimensional equilibria and island energy transport due to resonant magnetic perturbation edge localized mode suppression on DIII-DPhysics of Plasmas, 2015
- Development of the charge exchange recombination spectroscopy and the beam emission spectroscopy on the EAST tokamakReview of Scientific Instruments, 2014
- Faraday-effect polarimeter-interferometer system for current density measurement on EASTReview of Scientific Instruments, 2014
- Full toroidal plasma response to externally applied nonaxisymmetric magnetic fieldsPhysics of Plasmas, 2010
- Validation of the linear ideal magnetohydrodynamic model of three-dimensional tokamak equilibriaPhysics of Plasmas, 2010
- Edge stability and transport control with resonant magnetic perturbations in collisionless tokamak plasmasNature Physics, 2006
- The tokamak Monte Carlo fast ion module NUBEAM in the National Transport Code Collaboration libraryComputer Physics Communications, 2004
- Erratum: “Neoclassical conductivity and bootstrap current formulas for general axisymmetric equilibria and arbitrary collisionality regime” [Phys. Plasmas 6, 2834 (1999)]Physics of Plasmas, 2002
- Edge localized modes and the pedestal: A model based on coupled peeling–ballooning modesPhysics of Plasmas, 2002