Effect of post-fabrication treatments on surface residual stresses of additive manufactured stainless steel 316L
Authors:
- Kumar M.D. BarathKBKumar M.D. Barath
- K.M. AravindanKAK.M. Aravindan
- Jebaraj A. VinothJVJebaraj A. Vinoth
- Kumar T. SampathKSKumar T. Sampath
Open Access
- 1 January 2021
- journal article
- research article
- Published by Centre for Evaluation in Education and Science (CEON/CEES) in FME Transactions
- Vol. 49 (1) , 87-94
Abstract
In this work, an investigation was made to analyze the surface residual stresses on additive manufactured stainless steel AISI 316L in as-built and post-treated conditions. Direct metal laser sintering was used to fabricate the metal blocks. X-ray residual stress analysis on the as-fabricated surface revealed the presence of an inhomogeneous and irregular distribution of residual stresses in the as-built condition ranging from - 30 MPa to 111 MPa. It was mainly due to the localized laser heat source that caused variations in stresses at a lattice level. Heat treatment was performed for providing relief to the residual stress from the as-built condition showed significant relief of residual stress, which was lesser than 50% compared to as-built condition. Beneficial compressive residual stress induced by shot peening and lapping resulted in high magnitude compressive stresses on the surface. Also, homogeneous distribution of residual stress was found on the peened and lapped surface layer with an average of - 531 MPa and - 554 MPa, respectively.Keywords
This publication has 26 references indexed in Scilit:
- Mechanical behavior of additive manufactured, powder-bed laser-fused materialsMaterials Science and Engineering: A, 2016
- Evaluation of residual stress in stainless steel 316L and Ti6Al4V samples produced by selective laser meltingVirtual and Physical Prototyping, 2015
- Comparison of Residual Stresses in Inconel 718 Simple Parts Made by Electron Beam Melting and Direct Laser Metal SinteringMetallurgical and Materials Transactions A, 2015
- New Generation X-Ray Stress Measurement Using Debye Ring Image Data by Two-Dimensional DetectionMaterials Science Forum, 2014
- A Review of Additive ManufacturingISRN Mechanical Engineering, 2012
- Metal Fabrication by Additive Manufacturing Using Laser and Electron Beam Melting TechnologiesJournal of Materials Science & Technology, 2012
- Study on Reduction of Residual Stress Induced during Rapid Tooling Process: Influence of Heating Conditions on Residual StressKey Engineering Materials, 2010
- Investigations on residual stresses and deformations in selective laser meltingProduction Engineering, 2009
- Residual Stress within Metallic Model Made by Selective Laser Melting ProcessCIRP Annals, 2004
- On the development of direct metal laser sintering for rapid toolingJournal of Materials Processing Technology, 2003