Suppression of Stall-Induced Instability and Positive Slope at Low Flow Rates of an Axial Fan With Two-Dimensional Anti-Stall Fin
Open Access
- 3 October 2022
- journal article
- research article
- Published by ASME International in Journal of Fluids Engineering
- Vol. 144 (12)
Abstract
An axial fan in the general industry needs to secure stable characteristics in a wide operating range through an antistalling process, concerning its high demands, energy consumption, safety, and lifetime. As a “simple” and “original” method to control the stall of an axial fan, two-dimensional plates so-named anti-stall fin (ASF) were attached inside the casing and toward the shaft. The sensitivity analysis for design variables was conducted through the full factorial design method, and the optimization was performed using the response surface method (RSM). In the case of an axial fan without the ASF, the backflow gradually increased in the spanwise direction toward the hub and the streamwise direction to the inlet passage (upstream), as the flowrate decreased, and the rotating stall was developed through the quickening-growing-setting period. However, an ASF-attached axial fan stably recovered performance degradation in the stalling flow rates and allowed to form a negative slope to 0.5 . This study was mainly based on numerical simulations, while the performance before/after application of the ASF was validated through experimental tests.
Keywords
Funding Information
- Ministry of Trade, Industry and Energy (2021202080026D)
This publication has 31 references indexed in Scilit:
- On the Role of Leading-Edge Bumps in the Control of Stall Onset in Axial Fan BladesJournal of Fluids Engineering, 2013
- Flow control in axial fan inlet guide vanes by synthetic jetsEPJ Web of Conferences, 2013
- Active feedback control of stall in an axial flow fan under dynamic inflow distortionExperimental Thermal and Fluid Science, 2011
- Spike-Type Compressor Stall Inception, Detection, and ControlAnnual Review of Fluid Mechanics, 2010
- Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD ApplicationsJournal of Fluids Engineering, 2008
- Effects of Flow Settling Means on the Performance of Fan TesterJournal of Fluid Machinery, 2005
- ADAPTIVE RESPONSE SURFACE METHOD - A GLOBAL OPTIMIZATION SCHEME FOR APPROXIMATION-BASED DESIGN PROBLEMSEngineering Optimization, 2001
- Perspective: A Method for Uniform Reporting of Grid Refinement StudiesJournal of Fluids Engineering, 1994
- Two-equation eddy-viscosity turbulence models for engineering applicationsAIAA Journal, 1994
- Separation Control: ReviewJournal of Fluids Engineering, 1991