SYSang-Ho Yang

Sang-Ho Yang

*This is an algorithmically generated author record based on publicly available information.

Sang-Ho Yang has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Suppression of Stall-Induced Instability and Positive Slope at Low Flow Rates of an Axial Fan With Two-Dimensional Anti-Stall Fin

    by Yong-In Kim, Sang-Yeol Lee, Hyeon-Mo Yang, Kyoung-Yong Lee, Sang-Ho Yang, Young-Seok Choi

    An axial fan in the general industry needs to secure stable characteristics in a wide operating range through an antistalling process, concerning its high demands, energy consumption, safety, and lifetime. As a “simple” and “original” method to control the stall of an axial fan, two-dimensional plates so-named anti-stall fin (ASF) were attached inside the casing and toward the shaft. The sensitivity analysis for design variables was conducted through the 2k full factorial design method, and the optimization was performed using the response surface method (RSM). In the case of an axial fan without the ASF, the backflow gradually increased in the spanwise direction toward the hub and the streamwise direction to the inlet passage (upstream), as the flowrate decreased, and the rotating stall was developed through the quickening-growing-setting period. However, an ASF-attached axial fan stably recovered performance degradation in the stalling flow rates and allowed to form a negative slope to 0.5 Φd⁠. This study was mainly based on numerical simulations, while the performance before/after application of the ASF was validated through experimental tests.


  • Open Access

    Numerical Investigation of Performance and Flow Characteristics of a Tunnel Ventilation Axial Fan with Thickness Profile Treatments of NACA Airfoil

    by Yong-In Kim, Sang-Yeol Lee, Kyoung-Yong Lee, Sang-Ho Yang, Young-Seok Choi

    An axial flow fan, which is applied for ventilation in underground spaces such as tunnels, features a medium–large size, and most of the blades go through the casting process in consideration of mass production and cost. In the casting process, post-work related to roughness treatment is essential, and this is a final operation to determine the thickness profile of an airfoil which is designed from the empirical equation. In this study, the effect of the thickness profile of an airfoil on the performance and aerodynamic characteristics of the axial fan was examined through numerical analysis with the commercial code, ANSYS CFX. In order to conduct the sensitivity analysis on the effect of the maximum thickness position for each span on the performance at the design flow rate, the design of experiments (DOE) method was applied with a full factorial design as an additional attempt. The energy loss near the shroud span was confirmed with a quantified value for the tip leakage flow (TLF) rate through the tip clearance, and the trajectory of the TLF was observed on the two-dimensional (2D) coordinates system. The trajectory of the TLF matched well with the tendency of the calculated angle and correlated with the intensity of the turbulence kinetic energy (TKE) distribution. However, a correlation between the TLF rate and TKE could not be established. Meanwhile, the Q-criterion method was applied to specifically initiate the distribution of flow separation and inlet recirculation. The location accompanying the energy loss was mutually confirmed with the axial coordinates. Additionally, the nonuniform blade loading distribution, which was more severe as the maximum thickness position moved toward the leading edge (LE), could be improved significantly as the thickness near the trailing edge (TE) became thinner. The validation for the numerical analysis results was performed through a model-sized experimental test.