Studying the effect of fiber size and fiber loading on the mechanical properties of hybridized kenaf/PALF-reinforced HDPE composite
- 1 March 2011
- journal article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 30 (6) , 546-553
Abstract
Hybridization, especially where only variant natural lignocelluloses are combined, is fast receiving encouraging attention because it offers a range of properties that may be difficult to obtain with a single kind of reinforcement. In this study, tensile, flexural, and impact properties of hybridized kenaf/PALF-reinforced HDPE composite were studied. Sheets from which tensile, flexural, and impact specimens were cut out were produced from the compression molding of composite pellets and subsequently conditioned in an oven for 21 h at 103°C. The tensile and flexural specimens were tested according to ASTM D638 and ASTM D790 using a 5-kN INSTRON bluehill universal testing machine accordingly. While a notched Izoid impact test was conducted using a 1-J universal pendulum according to ASTM D256. All specimens were prepared at a fiber ratio of 1:1 kenaf:PALF and fiber lengths of 0.25, 0.5, 0.75, and 2 mm; fiber loadings of between 10% and 70% were utilized for the study. About 0.25 mm fiber showed the best tensile and flexural properties with a linear increase in properties up to 60% fiber loading while impact strength showed better property with 0.75 and 2 mm fiber lengths. At 0.25 mm fiber length, tensile strength of 32.24 MPa, flexural strength and modulus of 34.01 MPa and 4114.11 MPa, respectively, were observed at 60% fiber loading. Moduli results of all the composites formulated generally obeyed the ROM. SEM was used to examine the surface of composites produced. Tensile and impact strengths result showed inverse proportionality while flexural strength of the composite generally adhered to the ROM. However, a positive effect was observed in the case of composite’s impact strength in respect of increasing fiber length. Thus, reduction in some mechanical properties of the composite with respect to increasing fiber length is attributed more to fiber entanglement rather than attrition.Keywords
This publication has 18 references indexed in Scilit:
- Effect of Fiber Loading on the Mechanical Properties of Kenaf and Fiberfrax Fiber-reinforced Phenol-Formaldehyde CompositesJournal of Composite Materials, 2010
- Reinforced Thermoplastic Natural Rubber Hybrid Composites with Hibiscus cannabinus, L and Short Glass Fiber — Part I: Processing Parameters and Tensile PropertiesJournal of Composite Materials, 2008
- Mechanical properties of short flax fibre bundle/poly(ε-caprolactone) composites: Influence of matrix modification and fibre contentCarbohydrate Polymers, 2006
- A study of the mechanical properties of randomly oriented short banana and sisal hybrid fiber reinforced polyester compositesJournal of Applied Polymer Science, 2005
- Flax fiber surface modifications: Effects on fiber physico mechanical and flax/polypropylene interface propertiesPolymer Composites, 2005
- An investigation on the processing of sisal fibre reinforced polypropylene compositesComposites Science and Technology, 2003
- Natural fibres: can they replace glass in fibre reinforced plastics?Composites Science and Technology, 2003
- Effect of processing conditions on mechanical and viscoelastic properties of biocompositesJournal of Applied Polymer Science, 2003
- The effect of fiber treatment on the mechanical properties of unidirectional sisal-reinforced epoxy compositesComposites Science and Technology, 2001
- The nature of adhesion in composites of modified cellulose fibers and polypropyleneJournal of Applied Polymer Science, 1991