Evolution of Microstructure, Texture and Mechanical Properties for Multilayered Al Matrix Composites by Accumulative Roll Bonding
Open Access
- 26 September 2021
- Vol. 14 (19) , 5576
Abstract
Carbon nanotubes (CNTs) reinforced aluminum matrix nanocomposites were fabricated by Accumulative Roll Bonding (ARB). The surface morphologies, mechanical properties, grains texture and orientation of the Al/CNTs nanocomposites were characterized, and the mechanisms and influences of CNTs contents and ARB cycles on the mechanical performance and grain textures of Al/CNTs were investigated and revealed. The strength of the composites rose with increase of the CNTs content, and the ARB cycles showed a 26% improvement when the CNTs content varied from 0 to 1 volume percent (vol.%). The increase in the mass fraction of the carbon nanotubes made the grain distribution in the Al/CNTs nanocomposite samples more diffuse. Besides, the stable texture of the hot rolled crystal grains on the α orientation are constantly turning to {011}< 011> with the mass fraction of the reinforcing phase increased.Keywords
Funding Information
- the State Key Laboratory of Advanced Metals and Materials (No. 2019Z-08)
- the Fundamental Research Funds for the Central Universities (No. FRF-TP-18-038A1)
- The Hong Kong Polytechnic University (No. P18-0361)
This publication has 20 references indexed in Scilit:
- Enhanced interfacial bonding and mechanical properties in CNT/Al composites fabricated by flake powder metallurgyCarbon, 2018
- Preparation and properties of dual-matrix carbon nanotube-reinforced aluminum compositesComposites Part A: Applied Science and Manufacturing, 2017
- Balanced strength and ductility in CNT/Al composites achieved by flake powder metallurgy via shift-speed ball millingComposites Part A: Applied Science and Manufacturing, 2017
- Effectively enhanced load transfer by interfacial reactions in multi-walled carbon nanotube reinforced Al matrix compositesActa Materialia, 2017
- In-situ characterization of interfacial shear strength in multi-walled carbon nanotube reinforced aluminum matrix compositesCarbon, 2016
- Properties of high specific strength Al–4wt.% Al2O3/B4C nano-composite produced by accumulative roll bonding processMaterials & Design (1980-2015), 2013
- Effect of stacking fault energy on nanostructure formation under accumulative roll bonding (ARB) processMaterials Science and Engineering: A, 2013
- Development of aluminum hydroxides in Al–Mg–Si/SiCp in infiltrated composites exposed to moist airCeramics International, 2011
- Dispersion of C.I. Pigment Violet 23 in acetone using supercritical carbon dioxideJournal of the Taiwan Institute of Chemical Engineers, 2011
- Accelerated grain refinement during accumulative roll bonding by nanoparticle reinforcementScripta Materialia, 2011