Carbon fiber reinforced polyethylene composite adhesive at elevated temperatures
Authors:
- Weiqing FangWFWeiqing Fang
- Yu Hui ChengYCYu Hui Cheng
- Adam PearsonAPAdam Pearson
- Mark DuncanMDMark Duncan
- Joel RunkaJRJoel Runka
- Ahmed HammamiAhmed Hammami
- Hani E. NaguibHNHani E. Naguib
- 28 September 2023
- journal article
- research article
- Published by Elsevier in Composites Science and Technology
- Vol. 244
Abstract
No abstract availableKeywords
This publication has 39 references indexed in Scilit:
- Influence of the composite surface structure on the peel strength of metallized carbon fibre-reinforced epoxySurface and Coatings Technology, 2013
- Optimization of adhesive joints of low density polyethylene (LDPE) composite laminates with polyolefin foam using corona discharge plasmaJournal of Applied Polymer Science, 2009
- Peel-Zone Model of Tape Peeling Based on the Gecko Adhesive SystemThe Journal of Adhesion, 2007
- Predicting the permeability and tensile behavior of high density polyethylene/tie/polyamide 6 three‐layer filmsPolymer International, 2004
- Enhanced interfacial adhesion between polypropylene and nylon 6 by in situ reactive compatibilizationPolymer, 2004
- Modification of adhesive properties of a polyethylene film by photograftingJournal of Applied Polymer Science, 2004
- Modeling the failure of an adhesive layer in a peel testJournal of Polymer Science Part B: Polymer Physics, 2002
- Control of charging in low‐voltage SEMScanning, 1989
- The transition between ductile and slow-crack-growth failure in polyethylenePolymer, 1987
- Adhesion of viscoelastic materials to rigid substratesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1969