Effect of strain of cryorolling on structure and strength of nickel
- 1 December 2022
- journal article
- research article
- Published by Institute for Metals Superplasticity Problems of RAS in Letters on Materials
- Vol. 12 (4) , 409-413
Abstract
The effect of isothermal rolling at liquid nitrogen temperature with reductions up to 90 % on the structural-mechanical behavior of coarse-grained nickel was evaluated by TEM, SEM-EBSD and X-ray analysis methods, and microhardness measurements. The highest hardening rate of the metal was found at the initial stage of rolling (up to about 50 %), after which it decreased slightly with further reductions. Detailed analyses of the evolution of dislocation density, grain size and grain boundary spectra have shown that the behavior found was attributed to an extremely low deformation temperature, resulted in a decreased rate of accumulation of crystalline defects, as well as the formation and rearrangement of dislocation structure. Due to the strong suppression of dynamic recovery and recrystallization, even when rolling to a reduction of 90 %, a relatively homogeneous coarse-fibered structure with a developed nanocellular substructure and less than 5 % fraction of nanoscale dynamically recrystallized grains was formed. It was concluded that the main structural strengthening factors in cryogenically rolled nickel was the formation of low-energy dislocation structures and their transformations into a welldeveloped substructure with nanosized crystallites separated predominantly by low-angle boundaries.Keywords
This publication has 21 references indexed in Scilit:
- Nanostructured aluminium alloys produced by severe plastic deformation: New horizons in developmentMaterials Science and Engineering: A, 2013
- Microstructural response of pure copper to cryogenic rollingActa Materialia, 2010
- Ultrafine grain formation in face centered cubic metals during severe plastic deformationMaterials Science and Engineering: A, 2009
- Partial Grain Refinement in Al-3%Cu Alloy during ECAP at Elevated TemperaturesMATERIALS TRANSACTIONS, 2009
- The effect of cryogenic temperature and change in deformation mode on the limiting grain size in a severely deformed dilute aluminium alloyActa Materialia, 2008
- Ultrafine grain development in copper during multidirectional forging at 195 KPhilosophical Magazine Letters, 2007
- Nanostructural formation of fine grained aluminum alloy by severe plastic deformation at cryogenic temperatureJournal of Materials Science, 2004
- Dynamic Recrystallization Based on Twinning in Coarse-Grained MgMaterials Science Forum, 2003
- A metallographic and quantitative analysis of the influence of stacking fault energy on shock-hardening in Cu and Cu–Al alloysActa Materialia, 2001
- The influence of stacking fault energy on the mechanical behavior of Cu and Cu-Al alloys: Deformation twinning, work hardening, and dynamic recoveryMetallurgical and Materials Transactions A, 2001