Quantification of the Influence of Charge Variations on the Flow Behavior of Sheet Molding Compounds
Open Access
Abstract
Using a newly developed flow test bench, several charge configurations were analyzed to quantify the influence of the charge configuration in the mold in sheet molding compound (SMC) manufacturing. A test bench was developed to satisfy the industrial needs for the incoming goods inspection as well as the need for the flow characterization of rheological models in the simulation. The test setup has a cylindrical opening for the charge placement, from where the material is pressed into a thin flow channel, forcing the material to reorient. A comparison was performed by juxtaposing the resulting compression pressure recorded during the process. The charge for this test series, placed into the cylindrical opening, has two basal configurations, one consisting of a stack of disks, and the second in a rectangular sheet rolled up into a spiral. Six charge variations were tested in total. The amount of material, the batch, the layering and the production direction of the sheet proved to have a significant influence on the necessary compression pressure. Guidelines about the recommended charge configurations could be derived for optimized production settings, such as a reduction in the compression pressure and modifications to the charge.Keywords
Funding Information
- The German Federal Ministry for Economic Affairs and Climate Action (KK5135814)
This publication has 34 references indexed in Scilit:
- Sheet molding compound characterization using spiral flowJournal of Applied Polymer Science, 2008
- Predicting molding forces during sheet molding compounds (SMC) compression molding. II: Effect of SMC compositionPolymer Composites, 2003
- Effect of reinforcement type and length on physical properties, surface quality, and cycle time for sheet molding compound (SMC) compression molded partsJournal of Applied Polymer Science, 2003
- Predicting molding forces during sheet molding compound (SMC) compression molding. I: Model developmentPolymer Composites, 2003
- Anisotropy in sheet molding compounds during compression moldingPolymer Composites, 1997
- Compression molding simulation of chopped fiber reinforced polymeric composites in plate‐rib type geometryPolymer Composites, 1992
- Experimental and analytical procedures for flow dynamics of sheet molding compound (SMC) in compression moldingPolymer Composites, 1987
- Kinematics of flow in sheet molding compoundsPolymer Composites, 1985
- The rheology and mold flow of polyester sheet molding compoundPolymer Composites, 1981
- Predicting mold flow for unsaturated polyester resin sheet molding compoundsPolymer Composites, 1980