Fatigue Degradation and Martensitic Transformation of Austenitic Stainless Steel AlSi 321: New Results and Prospects
- 15 September 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 524-525, 899-904
Abstract
On ECRS-6 [1], we have presented first results of the researches of fatigue degradation and martensitic transformation of austenitic stainless steel AISI 321 by neutron diffraction stress analysis. A series of samples preliminary ex-situ cyclically fatigued at the frequency of 5 and 0.5 Hz was in-situ tested on the stress rig of the ENGIN instrument. In the high cycle fatigued (HCF) samples, the applied stress-elastic strain responses of austenite and martensite phases were find out to be strongly different as compared to the low cycle fatigued (LCF) samples, in which they are close. Moreover, the martensite Poisson ratio in the HCF-samples is almost twice to that of observed 0.28-0.30 in austenite and in both phases of the LCF-samples. With the purpose to search the reason of such unusual behavior of the martensite phase, one of the HCF-samples has been anew in-situ tested on the stress rig of the ENGIN-X in: 1) a LCF-mode at the frequency of 0.1 Hz to increase the fatigue level, and 2) a quasistatic mode to measure the applied stress-elastic strain responses of both phases. Also, two of the LCF-samples have been subjected to the ex-situ secondary HCF-testing at the frequency of 5 Hz and again in-situ measured on the ENGIN-X stress rig. Results of the mechanical characterization of phases in the twice fatigued austenitic stainless steel are presented and discussed.Keywords
This publication has 12 references indexed in Scilit:
- Scientific Review: ENGIN-X: A Fully Refined Diffractometer Designed Specifically for Measurement of StressNeutron News, 2004
- Time-of-flight neutron-diffraction investigations of elastic and anisotropy strains in fatigued austenitic stainless steelApplied Physics A, 2002
- Neutron-diffraction study of martensitic transformation in austenitic stainless steel under low-cycling tensile-compressive loadingApplied Physics A, 2002
- Neutron Diffraction Study of Plasticity-Induced Martensite Formation of the Austenitic Stainless Steel AISI 321Materials Science Forum, 2002
- Monitoring of low-cycle fatigue degradation in X6CrNiTi18-10 austenitic steelJournal of Nuclear Materials, 2001
- Cyclic deformation behaviour of AISI 321 austenitic steel and its characterization by means of HTC-SQUIDNuclear Engineering and Design, 2000
- Residual Stress Investigations in Austenitic Steel Samples WithDifferent Degree of Low Cycle FatigueTexture, Stress, and Microstructure, 1999
- Einfluß Von Mittelbeanspruchungen auf das Wechselverformungsverhalten and die verformungsinduzierte Martensitbildung des Stahls X6CrNiTi1810Materialwissenschaft und Werkstofftechnik, 1998
- Use of Rietveld refinement for elastic macrostrain determination and for evaluation of plastic strain history from diffraction spectraJournal of Applied Physics, 1997
- ENGIN — A new instrument for engineersPhysica B: Condensed Matter, 1997