Effects of automated fiber placement defects on high strain rate compressive response in advanced thermosetting composites
- 1 September 2021
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 55 (30) , 4549-4562
Abstract
The effects of fiber tow gaps, overlaps, and folds on the compressive strength of a fiber-placed composite laminate under dynamic loading conditions are investigated in this work. These layup defects were placed in the 0° fiber direction within a 24-ply quasi-isotropic laminate with a [45/0/–45/90]3S stacking sequence. Different locations of the defect were considered, namely near the bottom (in the 2nd ply), middle (10th ply) and top (23rd ply) of the laminate. High-strain rate compression experiments were conducted on composite that are pristine and with embedded defects using a split Hopkinson pressure bar (SHPB). The results were used to determine the strength knockdown due to the local changes in ply morphology because of fiber bed compaction in the presence of a layup defect. The experimental results revealed the anisotropy of in-plane strength coinciding with the deposited defect orientation. No significant variations in the residual strength were observed regarding the location of the defect (i.e., bottom, middle, or top) within the laminate. A morphological analysis based on microtomography of the cured defects indicates that the sources of the strength knockdown are due to the 0° ply drop-off, fiber misalignment in the adjacent 90° and 45° degree plies and the resin-rich region formed at the corner of the tapered 0° ply, between +45° and –45° laminas. The present study indicates the increased role of local morphological ply variations on the strength of composites under high-strain rate loading conditions, which should be considered during composite design.Keywords
This publication has 42 references indexed in Scilit:
- The engineering aspects of automated prepreg layup: History, present and futureComposites Part B: Engineering, 2012
- Experimental study of the effect of automated fiber placement induced defects on performance of composite laminatesComposites Part A: Applied Science and Manufacturing, 2011
- Strain Rate Dependence of Compressive Stress-Strain Loops of Several PolymersJournal of Solid Mechanics and Materials Engineering, 2008
- Impact Tensile Stress–strain Characteristics of Wrought Magnesium AlloysStrain, 2003
- Dynamic testing of fibre polymer matrix composite plates under in-plane compressionComposites Part A: Applied Science and Manufacturing, 2000
- Determination of the dynamic response of brittle composites by the use of the split Hopkinson pressure barComposites Science and Technology, 1999
- The static and dynamic axial collapse of fibreglass composite automotive frame railsComposite Structures, 1996
- Critical Appraisal of Limiting Strain Rates for Compression Testing of Ceramics in a Split Hopkinson Pressure BarJournal of the American Ceramic Society, 1994
- Compressive failure of fibre compositesJournal of the Mechanics and Physics of Solids, 1993
- An Investigation of the Mechanical Properties of Materials at very High Rates of LoadingProceedings of the Physical Society. Section B, 1949